本文關鍵詞：電網多環節系統可靠性評估　出處：《華南理工大學》2014年碩士論文　論文類型：學位論文

  更多相關文章： 電網多環節 系統可靠性 充裕度 網絡等值 微分傳遞

【摘要】：根據“統一調度、分級管理”原則，電網系統可被劃分為省級電網、地級電網和配電網三個傳輸環節。多環節系統可靠性是指由電源向負荷，，經過各個傳輸環節逐級傳遞，最終以供電可靠性指標來表征�？陀^定量評估電網多環節系統可靠性，能夠深入挖掘輸電網與配電網之間的作用機理，全面量化輸電網的可靠性水平對配電網可靠性的影響，全局把握電網的整體運行狀況以實現安全、穩定、可靠的運行目標。為此，本文所完成的主要工作和成果如下： 1）以傳統電網穩態充裕度評估理論為基礎，提出了新的算法和運算技術來保證計算精度的同時提高評估速度。以回路作為基本單位構建預想事故集合，并提出煙囪排序算法進一步減少無效的系統狀態；針對發電機故障狀態下機組再調度問題，提出按比例分配的經濟方案并確保發電機在出力范圍內；校正措施模型采用基于交流潮流的最優負荷削減模型；基于以上理論，充分挖掘當前計算機信息處理技術的潛力，研發大電網穩態充裕度評估軟件系統，并以IEEE RTS-79為算例驗證算法的有效性。 2）提出基于網絡等值的電網多環節系統可靠性評估方法。從網絡結構角度看，輸電網與配電網是電網多環節系統的有機組成部分，基于負荷-電源等值原則，將輸電網負荷點指標傳遞至配電網作為輸入?yún)?shù)；綜合運用網絡可達性理論與Warshall算法，實現多環節系統可靠性高效、科學的評估。以IEEE RTS-79和RBTS-BUS6相結合的完整電網系統作為算例，驗證了所提方法的實用性和可操作性，并得出實用化結論，為電網運行規劃人員提供快速有效的決策指導。 3）提出了基于微分傳遞的電網多環節系統可靠性靈敏度分析方法。首先建立可靠性指標函數；在負荷-電源等值模型基礎上，依據復合函數求導法則進行微分傳遞，推導系統可靠性指標對輸電網/配電網設備可靠性參數的靈敏度計算解析式；以IEEERTS-79和改進的RBTS-BUS6相結合的完整電網系統為算例驗證所提方法可有效探明系統的薄弱環節，為制定和完善電網可靠性控制措施、科學決策電網規劃方案提供理論支持和意見指導。 本文研究工作得到“以多環節綜合互動為特征的智能電網綜合示范工程”國家支撐計劃（2013BAA01B02）的資助。
[Abstract]:According to the "unified classification management" principle, the grid system can be divided into the provincial power grid, power grid and the level distribution network transmission link. The reliability of multi link system is defined by the power supply to the load, after each transmission link transfer step by step, and ultimately to the power supply reliability indices. The reliability of grid multi link system can objectively and quantitatively evaluate. Dig the mechanism between the transmission network and distribution network, affect the reliability level of comprehensive quantitative transmission system and the reliability of the distribution network, the overall grasp of the overall power grid to achieve a safe, stable and reliable operation of the target. Therefore, the main work and achievements of this paper are as follows:
1) based on the traditional steady-state adequacy evaluation theory, this paper puts forward a new algorithm and computing technology to ensure and improve its calculation accuracy evaluation speed. On the loop as the basic unit of construction of the contingency set, and proposes the chimney sorting algorithm further reduce the invalid system status; the generator fault condition and scheduling problem is proposed the economic plan and ensure the proportion of the output range of the generator; correction measures model using optimal load reduction model based on AC power flow; based on the above theory, fully tap the current computer information processing technology research and development potential, the steady-state adequacy evaluation software system, and to IEEE RTS-79 for example to verify the effectiveness of the algorithm.
2) the reliability evaluation methods of power grid network equivalent multi link system is proposed. From the perspective of network structure, transmission network and distribution network is the organic part of the grid multi link system, based on the principle of equivalent power load, load point index transmission network transfer to the distribution network as input parameters; using Network Accessibility Theory and Warshall algorithm, realize multi link system reliability efficient, scientific assessment. A complete grid system by combining IEEE RTS-79 and RBTS-BUS6 as an example, the proposed method is practical and operability, and draw practical conclusions, provide fast and effective decision-making guidance for operation personnel planning grid.
3) method is proposed to analyze the differential transmission grid multi link system reliability based on the sensitivity of reliability index. The first function is established; based on the equivalent model of power load, based on the composite function derivation rule of differential transmission, derivation of system reliability index of transmission / distribution network equipment reliability parameter sensitivity analysis formula to calculate the complete power system; based on IEEERTS-79 and improved RBTS-BUS6 for example to verify the proposed method can effectively explore the weak links of the system and to develop and improve the reliability of power grid control measures to provide theoretical support and guidance of scientific decision-making power network planning.
The research work is supported by the national support plan (2013BAA01B02) of "comprehensive demonstration project of intelligent power grid characterized by multi link and comprehensive interaction".

【學位授予單位】：華南理工大學
【學位級別】：碩士
【學位授予年份】：2014
【分類號】：TM732

【參考文獻】

相關期刊論文 前10條

1 別朝紅,王錫凡;雅可比矩陣的奇異性檢測和網絡孤島的判斷[J];電力系統自動化;1998年11期

2 程林,孫元章,鄭望其,晁劍;超大規模發輸電系統可靠性充裕度評估及其應用[J];電力系統自動化;2004年11期

3 任震,梁振升,黃雯瑩;交直流混合輸電系統可靠性指標的靈敏度分析[J];電力系統自動化;2004年14期

4 唐斯慶;張彌;李建設;吳小辰;蔣琨;舒雙焰;;海南電網“9·26"大面積停電事故的分析與總結[J];電力系統自動化;2006年01期

5 林濟鏗;王旭東;鄭衛洪;林昌年;;基于網絡化簡的計及開關故障配電網可靠性評估[J];電力系統自動化;2009年09期

6 謝紹宇;王秀麗;王錫凡;孫羽;;自適應重要抽樣技術在發輸電系統可靠性評估中的應用[J];電力系統自動化;2010年05期

7 汪隆君;王鋼;李博;;交直流混聯輸電系統充裕度評估的最優負荷削減模型[J];電力系統自動化;2011年07期

8 丁明,戴仁昶,洪梅,徐先勇;影響輸電網可靠性的氣候條件模擬[J];電力系統自動化;1997年01期

9 趙淵,周家啟,劉洋;發輸電組合系統可靠性評估中的最優負荷削減模型分析[J];電網技術;2004年10期

10 趙淵;周家啟;周念成;謝開貴;劉洋;況軍;;發輸電系統可靠性評估的啟發式就近負荷削減模型[J];電網技術;2005年23期

相關博士學位論文 前1條

1 汪隆君;電網可靠性評估方法及可靠性基礎理論研究[D];華南理工大學;2010年

本文編號：1393847