基于反激變換器的太陽能電池的均衡補償
[Abstract]:From the analysis of the current energy situation, solar power has become the main trend of energy in the future. Solar energy is a new clean energy, it has inexhaustible advantages, so the study of solar cells is very necessary. In this paper, the main research focus is the photovoltaic panel masking problem and the use of a suitable equalization compensation circuit to improve the energy output efficiency. In this paper, the mathematical model of photovoltaic module suitable for engineering simulation is selected, and the simulation model is built in PSIM to simulate the output characteristics of photovoltaic strings. As we all know, the shade of trees and the presence of dust will cause the problem of solar cells. When the PV panels are connected together, the output power of the whole array of photovoltaic panels will decrease and there will be more peaks when the shading occurs. The output efficiency of photovoltaic panels will be greatly affected. In this paper, firstly, the masking problem of photovoltaic panel is analyzed in detail, and the reason why the output power of photovoltaic panel is decreased is found out. Then, the principle scheme of equalizing using flyback converter is put forward, and the design method of circuit is given. The parameters of flyback converter are designed in detail, and the model of small signal is built, and a reasonable controller is designed. And the principle of maximum power point tracking MPPT is explained and designed. The simulation is carried out in PSIM, and the prototype of flyback equalization is made at the same time. In this paper, DSP is used to control, and the specific chip is the TMS320F28335, of TI manufacturer to complete the program control in DSP. Finally, the prototype is debugged, and the feasibility of the equalization compensation is verified according to the waveform. Flyback converter is used in this paper. It is not only simple circuit, easy to implement, but also low cost. At the same time, the problems of multi-peak and power reduction are solved. Meet the target requirements and realize the function.
【學位授予單位】:北方工業大學
【學位級別】:碩士
【學位授予年份】:2017
【分類號】:TM914.4
【參考文獻】
相關期刊論文 前9條
1 馮丹;任宏濱;寧飛;張興;;開關電源變換器的小信號建模設計[J];計算機仿真;2015年11期
2 劉迎;;國內外分布式光伏發電的發展現狀分析[J];現代國企研究;2015年16期
3 胡云巖;張瑞英;王軍;;中國太陽能光伏發電的發展現狀及前景[J];河北科技大學學報;2014年01期
4 毛亮;;我國發展太陽能光伏發電的必要性及技術分析[J];科技傳播;2011年20期
5 孟建輝;劉文生;;反激式變換器DCM與CCM模式的分析與比較[J];通信電源技術;2010年06期
6 劉邦銀;段善旭;劉飛;徐鵬威;;基于改進擾動觀察法的光伏陣列最大功率點跟蹤[J];電工技術學報;2009年06期
7 周林;武劍;栗秋華;郭珂;;光伏陣列最大功率點跟蹤控制方法綜述[J];高電壓技術;2008年06期
8 龍騰飛;丁宣浩;蔡如華;;太陽電池最大功率點跟蹤的三點比較法理論分析[J];節能;2007年08期
9 張超;何湘寧;;短路電流結合擾動觀察法在光伏發電最大功率點跟蹤控制中的應用[J];中國電機工程學報;2006年20期
相關博士學位論文 前3條
1 章治國;隔離型高增益正反激變換器拓?fù)渑c控制研究[D];重慶大學;2015年
2 佟強;數字DC-DC變換器動態性能和系統穩定性提高方法研究[D];哈爾濱工業大學;2010年
3 張方華;雙向DC-DC變換器的研究[D];南京航空航天大學;2005年
相關碩士學位論文 前8條
1 孫德達;光伏發電系統最大功率點跟蹤研究[D];山東大學;2014年
2 王冰清;光伏發電系統MPPT技術研究[D];北京交通大學;2014年
3 李躍;反激式開關電源箝位電路優化設計[D];中南大學;2013年
4 秦U,
本文編號:2368580
本文鏈接:http://sikaile.net/kejilunwen/dianlidianqilunwen/2368580.html