過充電條件下鋰離子電池?zé)崾Э財?shù)值模擬
本文選題:鋰離子電池 + 熱失控。 參考:《北京理工大學學報》2017年10期
【摘要】:采用數值模擬方法研究了過充電流(1C、2C、3C和4C)對三元鋰離子電池?zé)崾Э匦袨榈挠绊?基于多物理場耦合方法建立了過充電條件下鋰離子電池三維電-熱耦合模型,對電池發生熱失控的臨界時間,臨界溫度以及熱分布進行了模擬計算.模擬結果與試驗測量結果符合較好,各個測試點處的溫度和熱失控臨界點的誤差小于8%.過充電流對鋰離子電池?zé)崾Э氐呐R界溫度、臨界時間以及電池內外部溫差有較大影響:過充電流越大,電池發生熱失控的時間越短,臨界溫度越高,區域溫差越大,內外部溫差越大.
[Abstract]:The effect of overcharging current (1CX 2C3C and 4C) on the thermal runaway behavior of lithium-ion ternary batteries was studied by numerical simulation. Based on the multi-physical field coupling method, a three-dimensional electric-thermal coupling model of lithium ion battery under overcharge condition was established. The critical time, critical temperature and thermal distribution of the battery were simulated and calculated. The simulation results are in good agreement with the experimental results. The error of temperature and thermal runaway critical point at each test point is less than 8. The overcharge current has a great influence on the critical temperature, critical time and the temperature difference between the inner and outer parts of the lithium ion battery: the larger the overcharging current, the shorter the time of heat runaway, the higher the critical temperature, the greater the regional temperature difference. The greater the temperature difference between the interior and the exterior.
【作者單位】: 北京理工大學機電學院;中國電力科學研究院;
【分類號】:TM912
【相似文獻】
相關期刊論文 前10條
1 張振芳;對于熱失控問題的系統對策[J];蓄電池;1993年01期
2 紀化成,趙曉蘭;閥控式鉛酸蓄電池的熱失控[J];蓄電池;1997年01期
3 從志賢,付艷玲;固定型閥控式鉛酸蓄電池?zé)崾Э噩F(xiàn)象淺析[J];蓄電池;2005年01期
4 郭自強;;再談熱失控和脹肚問題[J];中國自行車;2009年12期
5 杭瑚,張立新,黃志剛,胡博路;閥控式鉛酸蓄電池中的氧循環與熱失控現象[J];蓄電池;1997年02期
6 閆智剛;;閥控式密封鉛酸蓄電池的熱失控[J];電動自行車;2010年09期
7 張維軍;;閥控式鉛酸蓄電池過熱失控分析[J];遼寧科技學院學報;2011年03期
8 劉炳華;;閥控式密封鉛蓄電池?zé)崾Э氐脑蚣邦A(yù)防[J];科技風;2010年23期
9 童一波,裘向明;固定型閥控式鉛酸蓄電池失效模式研究[J];電化學;1997年03期
10 孫成;閥控鉛酸蓄電池的熱失控及其對策[J];蓄電池;2003年03期
相關會議論文 前10條
1 劉長軍;閆麗萍;黃卡瑪;;微波加熱中“熱失控”的一維數值模擬[A];2005'全國微波毫米波會議論文集(第三冊)[C];2006年
2 王銘祥;;閥控密封鉛酸蓄電池的失水、熱失控故障原因分析及解決措施[A];2012年中國通信能源會議論文集[C];2012年
3 盧立麗;王松蕊;劉興江;;鋰離子電池的熱失控模擬[A];第二十八屆全國化學與物理電源學術年會論文集[C];2009年
4 何亮明;杜,
本文編號:1932049
本文鏈接:http://sikaile.net/kejilunwen/dianlidianqilunwen/1932049.html