本文關鍵詞： 模塊化多電平換流器 半橋子模塊 箝位雙子模塊 直流側故障 模型預測控制　出處：《中南大學學報(自然科學版)》2017年01期 　論文類型：期刊論文

【摘要】：針對當前已投入運行的高壓直流(HVDC)輸電工程中模塊化多電平換流器(MMC)存在子模塊數量較多、不具備阻斷直流側故障電流等問題,提出一種基于傳統MMC拓?fù)浣Y(jié)構的新型模塊化多電平拓?fù)?其橋臂由2個子模塊組串聯構成,2個子模塊組分別由半橋子模塊和箝位雙子模塊串聯組成,降低穩態運行損耗和元器件使用數量;闡述該新型拓?fù)涞幕緟?shù)選取原則及上、下2組子模塊的協調投切過程;針對新型MMC拓?fù)?采用相應的模型預測控制策略。最后,通過實驗進行驗證。研究結果表明:新型拓?fù)洳粌H具備阻斷直流側故障電流能力,而且在子模塊數量相同時,輸出電平數增多,交流電壓輸出波形更接近正弦波。
[Abstract]:In view of the problem that there are many sub-modules in the modularized multilevel converter MMCs in the HVDC transmission project that has been put into operation at present, it does not have the problem of blocking the DC side fault current, etc. A novel modularized multilevel topology based on traditional MMC topology is proposed. The bridge arm consists of two sub-modules in series and two sub-modules are composed of half-bridge submodules and clamped two-submodules in series. Reduce the steady operation loss and the number of components used; expound the principle of selecting the basic parameters of the new topology and the coordination switching process of the upper and lower groups of sub-modules; adopt the corresponding model predictive control strategy for the new MMC topology. Finally, The experimental results show that the new topology not only has the ability to block the DC side fault current, but also increases the output level when the number of sub-modules is the same, and the output waveform of AC voltage is closer to sine wave.
【作者單位】： 長沙理工大學電氣與信息工程學院;悉尼大學電氣與信息工程學院;
【基金】：湖南省教育廳創新平臺開放基金資助項目(16K004) 湖南省(長沙理工大學)研究生科研資助項目(CX2016B405)~~
【分類號】：TM721.1;TM46

【相似文獻】

相關期刊論文 前10條

1 白路;史U，

本文編號：1543358