【摘要】：通過對復合材料固化度和溫度相關黏彈性本構方程的分析,定義一個能綜合反映固化度和溫度等對復合材料黏彈性性能影響的無量綱參數De_m。當參數De_m都大于10~2時,復合材料基體處于流動狀態;當參數De_m都小于10~(-2)時,復合材料為彈性狀態;僅當部分參數De_m小于10~2而大于10~(-2)時,復合材料處于黏彈性狀態。以AS4纖維/3501-6樹脂復合材料為例,基于對其參數De_m在典型固化工藝過程中的演化,研究該復合材料黏彈性性能的發展過程,發現基于參數De_m分析得到的凝膠點時間與實驗結果一致。根據復合材料黏彈性性能對殘余應力發展的影響,將復合材料殘余應力計算分為流動階段和黏彈性階段,并建立了相應的狀態相關黏彈性本構模型。最后通過與原始模型預測結果的比較驗證了提出的本構模型,表明本文提出的計算方法與原始黏彈性本構模型計算結果一致,但大大降低了計算所需的時間和存儲空間。
[Abstract]:Based on the analysis of curing degree and temperature dependent viscoelastic constitutive equation of composites, a dimensionless parameter De_m. is defined, which can comprehensively reflect the effects of curing degree and temperature on the viscoelastic properties of composites. When the parameter De_m is more than 10 ~ (- 2), the matrix of the composite is in the flow state, and when the parameter De_m is less than 10 ~ (- 2), the composite is in the elastic state. Only when the partial parameter De_m is less than 10 ~ (- 2) and is greater than 10 ~ (- 2), the composite is in viscoelastic state. Taking the AS4 fiber / 3501 / 6 resin composite as an example, based on the evolution of its parameter De_m during the typical curing process, the development process of the viscoelastic properties of the composite was studied. It is found that the gel point time obtained by parametric De_m analysis is in agreement with the experimental results. According to the influence of viscoelastic properties of composite on the development of residual stress, the calculation of residual stress of composite is divided into flow stage and viscoelastic stage, and the corresponding state-dependent viscoelastic constitutive model is established. Finally, the proposed constitutive model is verified by comparing with the prediction results of the original model. It is shown that the calculation method proposed in this paper is consistent with the calculation result of the original viscoelastic constitutive model, but the time and storage space required for the calculation are greatly reduced.
【作者單位】： 武漢理工大學理學院;
【基金】：國家自然科學基金(11202154) 中央高�；究蒲袠I(yè)務費專項資金(WUT:2016IB002)
【分類號】：TB33

【相似文獻】

相關會議論文 前1條

1 陳航;馮雪;黃銀;;帶圖案軟界面的黏彈性分析與實驗[A];第十三屆全國實驗力學學術會議論文摘要集[C];2012年

，

本文編號：2448004