基于微通道的氧化鋅納米棒合成及生物熒光檢測研究
[Abstract]:In this paper, ZnO nanorods were synthesized in microchannels by hydrothermal method and seed layer induction method. The effects of synthesis time, flow rate and position in the channel on the morphology of ZnO nanorods were studied. On this basis, the application of ZnO nanorods in the detection of biological fluorescence was studied by using sheep anti-bovine IgG antibody (FITC-antilgG) labeled with fluorescein isothiocyanate as an example. The main contents are as follows: 1. ZnO nanorods were synthesized under traditional conditions and in microchannels. The morphology of ZnO nanorods was studied at the same time (3 h). It was found that the ZnO nanorods synthesized in microchannels were denser than those synthesized in traditional conditions. The orientation of C axis is better. At the same time, the growth of ZnO nanorods in different positions in microchannels was studied. The results showed that the growth of ZnO nanorods in different locations of microchannels also showed regular changes. 2. The flow rate of growth solution was 10 渭 L / min, and the morphology of ZnO nanorods varied with the synthesis time during 1-6 h. The results showed that the diameter and length of ZnO nanorods synthesized in microchannels increased first and then decreased with the increase of synthesis time. ZnO nanorods were synthesized in microchannels for 3 h, and the flow rate of growth solution varied from 2 to 12 渭 L/min. The effect of flow rate on the morphology of ZnO nanorods was studied. The results show that the length and diameter of the ZnO nanorods synthesized in the microchannels increase first and then decrease with the increase of flow velocity. ZnO nanorods prepared under different synthetic conditions were used as carriers for the detection of biological fluorescence. The fluorescence enhancement of ZnO nanorods with different morphologies for FITC-antiIgG detection was studied. The results showed that the ZnO nanorods prepared at a flow rate of 10 渭 L / min and synthesis time of 3 h had the best fluorescence detection performance. It was found that when the concentration of protein was in the range of 1.0 脳 104 渭 g/mL, the logarithmic value of fluorescence intensity and protein concentration showed a linear change, and the detection limit could reach 1.Ox104 渭 g / mL.
【學位授予單位】:華東師范大學
【學位級別】:碩士
【學位授予年份】:2015
【分類號】:TB383.1;O614.241
【相似文獻】
相關期刊論文 前10條
1 陳永平;肖春梅;施明恒;吳嘉峰;;微通道冷凝研究的進展與展望[J];化工學報;2007年09期
2 胡雪;魏煒;雷建都;馬光輝;蘇志國;王化軍;;T型微通道裝置制備尺寸均一殼聚糖微球[J];過程工程學報;2008年01期
3 甘云華;楊澤亮;;軸向?qū)釋ξ⑼ǖ纼?nèi)傳熱特性的影響[J];化工學報;2008年10期
4 楊凱鈞;左春檉;丁發喜;王克軍;呂海武;曹倩倩;王吉順;;微通道散熱器長直微通道的新加工工藝研究[J];吉林化工學院學報;2011年09期
5 付濤濤;朱春英;王東繼;季喜燕;馬友光;;微通道內氣液傳質特性[J];化工進展;2011年S2期
6 卜永東;沈寅麒;杜小澤;楊立軍;楊勇平;;仿蜂巢微通道分叉結構的甲醇重整制氫[J];化工學報;2013年06期
7 宋善鵬;于志家;劉興華;秦福濤;方薪暉;孫相_g;;超疏水表面微通道內水的傳熱特性[J];化工學報;2008年10期
8 李鑫;陳永平;吳嘉峰;施明恒;;寬矩形硅微通道中流動冷凝的流型[J];化工學報;2009年05期
9 馬璨;袁惠新;楊振東;魯娣;;微反應器矩形微通道截面高寬比對流速的影響[J];環境科學與技術;2009年10期
10 李彩霞;王斯民;胡鵬睿;;等壁溫下平行微通道內層流換熱的數值模擬[J];化學工程;2012年03期
相關會議論文 前10條
1 逄燕;劉趙淼;;溫黏關系對微通道內液體流動和傳熱性能的影響[A];北京力學會第18屆學術年會論文集[C];2012年
2 范國軍;逄燕;劉趙淼;;微通道中液體流動和傳熱特性的影響因素概述[A];北京力學會第18屆學術年會論文集[C];2012年
3 劉麗昆;逄燕;劉趙淼;;幾何參數對微通道液體流動和傳熱性能影響的研究[A];北京力學會第18屆學術年會論文集[C];2012年
4 史東山;李錦輝;劉趙淼;;關于微通道相關問題研究方法現狀分析[A];北京力學會第18屆學術年會論文集[C];2012年
5 劉麗昆;劉趙淼;申峰;;幾何參數對微通道黏性耗散影響的研究[A];北京力學會第19屆學術年會論文集[C];2013年
6 肖鵬;申峰;劉趙淼;;微通道中矩形微凹槽內流場的數值模擬[A];北京力學會第19屆學術年會論文集[C];2013年
7 肖鵬;申峰;劉趙淼;李易;;凹槽微通道流場的三維數值模擬[A];北京力學會第20屆學術年會論文集[C];2014年
8 周繼軍;劉睿;張政;廖文裕;佘漢佃;;微通道傳熱中的兩相間歇流[A];上海市制冷學會2011年學術年會論文集[C];2011年
9 夏國棟;柴磊;周明正;楊瑞波;;周期性變截面微通道內液體流動與傳熱的數值模擬研究[A];中國力學學會學術大會'2009論文摘要集[C];2009年
10 胡國慶;;復雜微通道中的液滴控制(英文)[A];2010年第四屆微納米海峽兩岸科技暨納微米系統與加工制備中的力學問題研討會摘要集[C];2010年
相關重要報紙文章 前2條
1 本報記者 陳杰;空調將進入微通道時代[N];科技日報;2008年
2 張亮;美海軍成功為未來武器研制微型散熱器[N];科技日報;2005年
相關博士學位論文 前10條
1 趙亮;電動效應作用下微通道內液體流動特性[D];哈爾濱工業大學;2009年
2 李志華;微通道流場混合與分離特性的研究[D];浙江大學;2008年
3 季喜燕;微通道內氣液兩相流動及傳質過程研究[D];天津大學;2011年
4 賀占蜀;交錯互通微通道多孔網格板制造及其強化傳熱研究[D];華南理工大學;2011年
5 范曉光;微通道內蒸汽及混合蒸氣冷凝流動與傳熱[D];大連理工大學;2012年
6 劉江濤;微通道內單相和相變傳熱機理與界面特性[D];清華大學;2008年
7 全曉軍;硅基梯形微通道內水蒸汽凝結換熱特性及等溫同向噴射流研究[D];上海交通大學;2008年
8 金慶輝;微通道電泳芯片系統的原理、方法和應用研究[D];中國科學院研究生院(上海微系統與信息技術研究所);2002年
9 張?zhí)锾?微通道內氣體流動換熱的理論與實驗研究[D];北京交通大學;2011年
10 曹彬;微通道反應器的傳遞和反應特性[D];中國科學院研究生院(大連化學物理研究所);2005年
相關碩士學位論文 前10條
1 劉征;超疏水微通道傳遞特性的數值模擬[D];大連理工大學;2010年
2 高曉玉;微通道光生物制氫反應器內微生物生長及傳輸特性[D];重慶大學;2010年
3 劉煥玲;微通道換熱研究[D];西安電子科技大學;2004年
4 劉瑩瑩;網絡化微通道散熱器的設計仿真與溫度控制[D];西安電子科技大學;2008年
5 劉秉言;微通道中流動特性的大渦模擬[D];天津大學;2007年
6 趙向陽;光學表面等離子共振生物傳感器的微通道系統研究及儀器設計[D];河南農業大學;2008年
7 逄燕;微通道內液體流動和換熱特性的數值模擬研究[D];北京工業大學;2011年
8 葛浩;新型微通道熱沉的設計和數值研究[D];上海交通大學;2007年
9 謝靈丹;微通道內微細顆粒對氣液傳質的影響研究[D];天津大學;2010年
10 劉超;裝有縱向渦流產生器的矩形微通道內的傳熱與流動的實驗和模擬研究[D];華中科技大學;2011年
,本文編號:2397097
本文鏈接:http://sikaile.net/kejilunwen/cailiaohuaxuelunwen/2397097.html