本文選題：熱固性樹脂基復合材料　切入點：熱隔膜成型　出處：《復合材料學報》2016年07期 　論文類型：期刊論文

【摘要】：為研究制件成型過程中的層間滑移情況及固化后的回彈變形,首先,利用自行開發的熱隔膜成型裝置制備了熱固性樹脂基復合材料C型制件。同時,針對熱隔膜成型過程建立了三維數值仿真模型;該模型由3個復合材料固化過程子模型構成,包括熱-化學模型、層間滑移模型和固化變形模型。然后,在此基礎上將固化過程中復合材料性能的時變特性引入到仿真模型中,并將仿真結果與文獻中的實驗結果進行比較。最后,利用建立的仿真模型對熱隔膜成型過程進行了數值模擬,并與實驗進行比對,重點研究了成型過程中溫度、固化度分布、層間滑移以及固化變形情況。所得結果證明所建立的數值模型對熱隔膜成型過程的預測具有較高的可靠性及準確性,可以為后續熱隔膜成型參數優化和模具修正提供參考。
[Abstract]:In order to study the interlaminar slip and springback deformation during the forming process of the parts, the thermosetting resin matrix composites C type parts were prepared by using the thermal diaphragm forming device developed by ourselves, at the same time, A three-dimensional numerical simulation model is established for the forming process of thermal diaphragm, which consists of three sub-models of curing process of composite materials, including thermo-chemical model, interlaminar slip model and solidification deformation model. On this basis, the time-varying properties of composite materials during the curing process are introduced into the simulation model, and the simulation results are compared with the experimental results in the literature. Finally, The simulation model is used to simulate the forming process of the thermal diaphragm, and compared with the experiment, the distribution of temperature and curing degree during the forming process is studied emphatically. The results show that the established numerical model has high reliability and accuracy in predicting the forming process of the thermal diaphragm, and can provide a reference for the optimization of the forming parameters of the thermal diaphragm and the modification of the die.
【作者單位】： 西北工業大學陜西省數字化制造工程技術研究中心;中航飛機股份有限公司西安飛機分公司;
【基金】：國家自然科學基金(51275420)
【分類號】：TB33
，

本文編號：1584260