【摘要】：采用CFD離散相物理模型對采煤工作面不同割煤方式煤塵擴散進行模擬,對模型中5條代表性直線進行煤塵濃度檢測,得出具有普遍試用的一般性煤塵擴散規律。發現順風割煤時煤塵水平方向擴散速度快,但局限于采煤工作面底部范圍,中心線濃度在煤機后10~15 m達到峰值;逆風割煤時煤塵垂直方向擴散速度快,中心線濃度在煤機后5~10 m達到峰值,并且煤塵濃度峰值高于順風割煤煤塵濃度峰值。2種割煤方式煤塵濃度在煤機后40~50 m處在水平方向達到基本穩定,垂直方向煤塵底板濃度高于頂板濃度。
[Abstract]:The CFD discrete phase physical model is used to simulate the coal dust diffusion in different coal cutting modes in coal mining face. Five representative lines in the model are tested for coal dust concentration, and the general coal dust diffusion rule with universal trial is obtained. It is found that the horizontal diffusion speed of coal dust is fast when cutting coal with wind, but it is limited to the bottom of coal mining face, and the concentration of the center line reaches the peak value at 10 ~ 15 m after coal mining. When cutting coal by reverse wind, the vertical diffusion speed of coal dust is fast, and the concentration of the center line reaches the peak value at 5-10 m behind the coal-mining machine. The peak value of coal dust concentration is higher than that of Shunfeng cut coal dust concentration. The coal dust concentration of the two coal cutting methods is basically stable in the horizontal direction at 40 m after coal mining, and the vertical coal dust floor concentration is higher than the roof concentration.
【作者單位】： 山東科技大學機械電子工程學院;
【基金】：中國博士后科學基金面上資助項目(2015M572061)
【分類號】：TD714
，

本文編號：2466264