【摘要】：本論文針對內蒙古大唐國際錫林浩特礦業有限公司M102、M103、M106三個皮帶驅動站的逸塵問題，經過現場考察調研測得了現場粉塵特性，經過實驗研究分析了粉塵的潤濕性、爆炸性和自燃傾向性，并根據現場具體情況并結合當?shù)貧夂�、水資源條件等對其進行了皮帶驅動車間粉塵綜合治理改造設計，介紹了高壓微霧除塵系統的組成及運行，使得高壓微霧除塵系統在皮帶驅動站粉塵治理中得以實際應用，通過計算現場試驗分析得出最佳的噴霧參數：噴嘴孔徑為0.5mm，噴霧壓力為5~7MPa，霧滴粒徑為3μm~30μm，在產塵源頭有效捕捉粉塵微粒達到降塵作用，降塵效率達80%~90%。粉塵治理后有效提高了員工的工作效率，降低了機械設備的損耗率，減少了企業對于職業病防治的投入成本及耗水成本，取得了良好的社會經濟效益。
[Abstract]:In this paper, aiming at the problem of dust escape in three belt driving stations of Datang International Xilinhaote Mining Co., Ltd., Inner Mongolia, through field investigation and investigation, the field dust characteristics are measured, and the wettability of dust is analyzed through experimental research. According to the specific situation of the site, combined with the local climate and water resources condition, the comprehensive control design of dust in the belt drive workshop is carried out. The composition and operation of the dust removal system with high pressure micro-fog are introduced. The dust removal system of high pressure micro fog can be applied in the dust treatment of belt drive station. The optimum spray parameters are obtained through field test and analysis: the nozzle diameter is 0.5 mm, the spray pressure is 5 ~ 7 MPa, the droplet diameter is 3 渭 m ~ (-1) 30 渭 m, and the diameter of droplet is 3 渭 m ~ (30 渭 m). The dust particles can be effectively captured at the source of dust production, and the dust reduction efficiency is 80% and 90% respectively. After dust treatment, the working efficiency of employees is improved, the loss rate of machinery and equipment is reduced, the input cost and water consumption cost of prevention and treatment of occupational diseases are reduced, and good social and economic benefits are obtained.
【學位授予單位】：遼寧工程技術大學
【學位級別】：碩士
【學位授予年份】：2013
【分類號】：TD714.4

【參考文獻】

相關期刊論文 前10條

1 葛少成;齊慶杰;邵良山;;選煤廠毛煤倉倉頂粉塵析出機理與控制技術[J];遼寧工程技術大學學報;2007年03期

2 葛少成;齊慶杰;邵良杉;;毛煤倉下粉塵污染原因及處理[J];遼寧工程技術大學學報;2007年04期

3 葛少成;邵良杉;齊慶杰;;選煤廠轉運點除塵方案模擬優化設計[J];遼寧工程技術大學學報;2007年06期

4 張大明;馬云東;;礦井粉塵污染防治新技術淺析[J];遼寧工程技術大學學報(自然科學版);2009年S2期

5 葛少成;荊德吉;黃瑩品;;基于數值模擬的高壓微霧除塵原理及其技術參數確定[J];遼寧工程技術大學學報(自然科學版);2012年01期

6 施學貴,徐旭常,馮俊凱;顆粒在湍流氣流中運動的受力分析[J];工程熱物理學報;1989年03期

7 吳瓊;題正義;;綜采工作面噴霧降塵技術研究[J];礦業工程;2007年04期

8 周威明,余澄海;粉塵控制新技術[J];工業安全與環保;2004年03期

9 張小艷,郭強,李全;微細水霧除塵技術的實驗研究[J];環境污染與防治;2003年04期

10 于明州,金晗輝,陳麗華,樊建人,岑可法;粉塵粒子運動擴散特性的大渦模擬研究[J];環境科學學報;2005年07期

，

本文編號：2362476