發布時間：2018-06-05 14:15

  本文選題：工業槽 + 射流��； 參考：《中國安全生產科學技術》2017年05期

【摘要】：槽邊射流吹吸罩已廣泛應用,但以射流理論為基礎的計算方法多通過經驗確定關鍵控制參數,并進行設計和應用,忽略了一些因素對吹吸流場的影響,難以準確確定槽邊射流吹吸罩控制面板位置和控制污染物所需最小風速的要求。因此,以蘇聯巴杜林的射流末端速度法為例,利用計算機流體力學計算技術,對不同送排風速情況下三維槽邊射流吹吸罩的流場分布和毒物控制效果進行模擬分析,確定槽邊射流吹吸罩控制面位于0.6~0.8 L的位置,一般取0.65 L的位置,為防止污染物擴散,控制面的風速不宜小于1.28 m/s。
[Abstract]:The fluted jet suction cover has been widely used, but the calculation method based on the jet theory determines the key control parameters by experience, designs and applies, and neglects the influence of some factors on the suction field. It is difficult to determine the position of the control panel and the minimum wind speed required to control the pollutants. Therefore, taking the end velocity method of jet in Badulin, USSR, as an example, the flow field distribution and toxic control effect of three dimensional jet suction hood with different feeding and discharging wind speeds are simulated and analyzed by using computer hydrodynamic calculation technology. It is determined that the control surface of the fluted jet suction hood is located at the position of 0.6m 0.8 L, and the position of 0.65 L is generally taken. In order to prevent the diffusion of pollutants, the wind speed of the control surface should not be less than 1.28 m / s.
【作者單位】： 中國安全生產科學研究院;塵毒危害預防與控制技術國家安全生產監督管理總局安全生產重點實驗室;
【基金】：“十二五”國家科技支撐計劃課題(2015BAK40B01) 國家重點研發計劃(2016YFC0801702,2016YFC0801705) 中國安全生產科學研究院基本科研業務費專項資金項目(2016JBKY01,2016JBKY18,2016JBKY07,2016JBKY09,2017JBKY07)
【分類號】：X962
，

本文編號：1982266