發布時間：2018-07-07 09:44

  本文選題：水泵軸系 + 特征參數�。� 參考：《排灌機械工程學報》2017年08期

【摘要】：將立式水泵機組軸系結構簡化為三支承二圓盤的集中參數模型,建立了電動機轉子和水泵轉輪形心軌跡的運動方程,進而獲得穩態下形心軌跡的解析表達式.利用水泵機組無水啟動試驗的特殊性和近似處理,給出了電動機轉子和水泵轉輪固有頻率和阻尼比的計算方法.以某泵站無水啟動的軸系擺度實測數據為例,根據軸系幾何結構擬合軸系擺度形態,結合多轉速下的測試數據,采用多項式擬合方法獲得轉子和轉輪擺度數據.利用擬合得到的轉子和轉輪擺度數據計算水泵機組軸系特征參數,并對計算中的相關問題進行了分析說明.采用文中所提出的方法,可計算得到水泵轉輪和電動機轉子的固有頻率轉速、阻尼比和質量偏心等振動特征參數,且計算結果具有一定的數值穩定性.由于采用實測數據進行計算,所獲得的振動特征參數包含了安裝、調試等不確定性因素的影響,對于已安裝運行的水泵機組振動研究具有參考價值.
[Abstract]:The shafting structure of a vertical pump unit is simplified as a lumped parameter model with three supports and two disks, and the motion equations of the centroid locus of the motor rotor and the pump runner are established, and the analytical expression of the centroid trajectory under steady state is obtained. Based on the particularity and approximate treatment of water-free start-up test of water pump unit, the calculation method of natural frequency and damping ratio of motor rotor and pump runner is given. Taking the measured shafting data of a pump station as an example, according to the shafting geometry structure fitting shafting form, combining with the test data under multi-rotation speed, the data of rotor and runner pendulum are obtained by polynomial fitting method. The characteristic parameters of water pump unit shafting are calculated by using the data of rotor and runner pendulum, and the related problems in calculation are analyzed and explained. The vibration characteristic parameters such as natural frequency speed damping ratio and mass eccentricity of the pump runner and motor rotor can be calculated by using the method presented in this paper. The calculated results have certain numerical stability. Because the measured data are used to calculate, the vibration characteristic parameters obtained include the influence of uncertain factors such as installation and debugging, which is of reference value for the vibration research of the pump units that have been installed and run.
【作者單位】： 云南省水利水電投資有限公司;云南水投牛欄江滇池補水工程有限公司;
【分類號】：TH38

【相似文獻】

相關期刊論文 前9條

1 王軍;吳鳳和;張艷;;基于產品結構特征參數的實例搜索與修改方法[J];農業工程學報;2012年23期

2 李郝林;故障特征參數有效性的模糊信息熵判據[J];信息與控制;1995年05期

3 何雨馨;劉文彬;王華慶;楊劍鋒;;基于遺傳編程的軸承信號特征參數構造方法研究[J];測控技術;2014年03期

4 張旺峰;曹春曉;李興無;馬濟民;朱知壽;;鈦合金組織特征參數與拉伸性能預測[J];稀有金屬材料與工程;2009年06期

5 竇萬鋒，，蘇志霄，齊維浩;工程圖譜特征提取[J];機械設計與研究;1995年03期

6 駱志高;范祥偉;陳強;;金屬拉伸件拉伸過程微裂紋AE信號特征參數的優化及狀態識別[J];振動與沖擊;2012年17期

7 吳惠祥,朱劍英,左洪福;磨粒特征參數的篩選及權分析[J];南京航空航天大學學報;2002年05期

8 苗恩銘;;精確熱膨脹特征參數的精度分析[J];農業機械學報;2006年04期

9 ;[J];;年期

本文編號：2104572