本文關鍵詞： 液壓缸試驗 關鍵技術 內泄漏 負載效率 起動壓力　出處：《沈陽工業大學》2017年碩士論文　論文類型：學位論文

【摘要】：隨著科學技術的發展,對液壓缸的性能要求也越來越高,伴隨著對液壓缸試驗的要求也越來越高。我國液壓缸試驗和測控技術測量精度不高、自動化程度不高、智能化程度不高,液壓缸試驗和測控技術的落后嚴重制約我國液壓缸的生產質量。因此,我們急需設計更完善的液壓缸試驗,提高液壓缸的生產技術水平和液壓缸的性能。介紹了液壓缸型式試驗原理及系統組成,對其重要的測控特性進行了研究分析。綜述了液壓缸的發展現狀、液壓缸試驗的研究意義以及國家標準規定的試驗內容等。對液壓缸型式試驗的關鍵技術內泄漏測量,負載效率的測量,起動壓力測量幾項關鍵技術進行設計,并對其進行應用與分析。該試驗?zāi)軐?shí)現對液壓缸出廠性能的檢測,多種試驗可以同步進行,可以實現遠程的無級調壓,復合調速,比例加載,系統試驗全自動智能控制。針對液壓缸試驗中的內泄漏測量、負載效率測量、起動壓力測量關鍵技術問題重點研究,結合實際情況,設計出了高精度的檢測系統。對內泄漏的測量采用溫度標定法,可以在線實時測量并且檢測精度非常高;對負載效率的測量,采用比例溢流閥調壓,激光測量儀監控活塞桿位移狀態,可在線精準測量并繪制圖表;對于起動壓力的測量,采用節流閥和小量程壓力表,在線精準測量起動壓力,試驗結果精準可靠。試驗結果表明該試驗技術檢測穩定可靠,準確高效,大大提高了生產效率,為液壓缸生產技術水平的提高提供了可靠的依據,對液壓缸的生產與檢測具有重大的指導意義。
[Abstract]:With the development of science and technology, the requirement of hydraulic cylinder performance is higher and higher. The degree of intelligence is not high, and the backwardness of the hydraulic cylinder test and measurement and control technology seriously restricts the production quality of the hydraulic cylinder in our country. Therefore, we urgently need to design more perfect hydraulic cylinder test. This paper introduces the principle and system composition of hydraulic cylinder type test, studies and analyzes its important measurement and control characteristics, and summarizes the development status of hydraulic cylinder, and improves the production technology level of hydraulic cylinder and the performance of hydraulic cylinder, introduces the principle and system composition of hydraulic cylinder type test, and analyzes its important measurement and control characteristics. The research significance of the hydraulic cylinder test and the content of the test stipulated by the national standard, etc. The key technologies of the hydraulic cylinder type test, such as internal leakage measurement, load efficiency measurement, starting pressure measurement and so on, are designed. The test can be used to detect the performance of hydraulic cylinder, and many tests can be carried out synchronously, which can realize remote stepless voltage regulation, compound speed regulation, proportional loading, etc. Automatic intelligent control of system test. According to the key technical problems of internal leakage measurement, load efficiency measurement and starting pressure measurement in hydraulic cylinder test, combined with the actual situation, A high precision detection system is designed. The temperature calibration method is used to measure internal leakage, which can be measured online in real time and has a very high detection accuracy, and for load efficiency measurement, the proportional relief valve is used to adjust the pressure. Laser measuring instrument monitors piston rod displacement, can be accurately measured and plotted on line. For starting pressure measurement, throttle valve and small range pressure gauge are used to accurately measure starting pressure on line. The test results show that the testing technology is stable, reliable, accurate and efficient, and greatly improves the production efficiency, which provides a reliable basis for the improvement of the production technology level of hydraulic cylinder. It is of great significance to the production and inspection of hydraulic cylinder.
【學位授予單位】：沈陽工業大學
【學位級別】：碩士
【學位授予年份】：2017
【分類號】：TH137.51

【參考文獻】

相關期刊論文 前10條

1 周俊中;;液壓缸內泄漏檢測方法的改進[J];潤滑與密封;2009年09期

2 曾億山;李文新;夏永勝;;液壓缸綜合試驗臺的控制軟件設計[J];流體傳動與控制;2009年01期

3 鄧飆;邱義;張寶生;;液壓缸行程檢測技術研究現狀[J];液壓與氣動;2008年11期

4 吳勇;孫照富;;壓力傳感器性能試驗臺液壓伺服系統設計[J];液壓與氣動;2008年08期

5 郭俊英;;淺談液壓油缸加載試驗臺系統的設計[J];科學之友(B版);2008年07期

6 潘忠秀;何鎖山;;一種新型立式液壓缸試驗臺[J];建筑機械;2008年01期

7 李廈;烏建中;;液壓缸試驗臺自動測試系統設計與實現[J];機械設計與制造;2007年10期

8 雷杰;;50 MPa液壓綜合試驗臺的設計與研究[J];陜西科技大學學報(自然科學版);2007年01期

9 史俊青;孫政;王連洪;程艷;徐東升;;液壓缸性能測試試驗臺的研究[J];工程機械;2006年02期

10 孫永厚;液壓綜合試驗臺設計[J];工程機械;2003年11期

，

本文編號：1524438