預應力混凝土裝配框架中節點抗震性能試驗研究
本文關鍵詞: 裝配框架 中節點 預應力混凝土 擬靜力試驗 抗震性能 出處:《建筑結構學報》2015年S2期 論文類型:期刊論文
【摘要】:對2個現澆混凝土中節點和2個預應力裝配框架中節點進行了低周往復加載試驗,以配筋率(分別為0.7%和1.0%)作為變量,在中節點試件的柱端上部施加低周反復水平荷載,對比分析了現澆節點與裝配節點的滯回曲線、骨架曲線、延性系數、耗能能力、剛度曲線和剪切變形,研究了在不同連接方式下配筋率對節點抗震性能的影響。研究結果表明:預應力混凝土裝配框架中節點發生的是梁端受彎破壞,卸載后的殘余變形明顯小于現澆試件,配筋率較小的試件的裂縫較集中在梁柱交界處,混凝土更容易脫落。配筋率較高的試件滯回曲線較飽滿,承載力衰減的程度減緩。裝配試件節點核心區的抗裂性能、剛度和變形恢復能力較好,延性系數在3.2~4.0之間,預應力筋有緩解裂縫過早出現,削弱剪切變形的作用。
[Abstract]:Two in-situ concrete joints and two joints in prestressed assembly frame were subjected to low-cycle reciprocating loading tests. The reinforcement ratio (0.7% and 1.0 respectively) was used as variables to apply low-cycle repeated horizontal load on the top of the column end of the mid-joint specimen. The hysteretic curve, skeleton curve, ductility coefficient, energy dissipation capacity, stiffness curve and shear deformation of cast-in-place and assembly joints are compared and analyzed. The effect of reinforcement ratio on the seismic behavior of joints under different connection modes is studied. The results show that the joints of prestressed concrete assembly frame are subjected to bending failure at the end of beam, and the residual deformation after unloading is obviously smaller than that of cast-in-place specimens. The cracks of the specimens with lower reinforcement ratio are concentrated at the junction of Liang Zhu, and the concrete is easier to fall off. The hysteretic curve of the specimen with higher reinforcement ratio is fuller, and the degree of bearing capacity attenuation is reduced. The stiffness and deformation recovery ability are better, the ductility coefficient is between 3.2 and 4.0, the prestressing tendons can alleviate the premature occurrence of cracks and weaken the shear deformation.
【作者單位】: 華北理工大學建筑工程學院;河北省地震工程研究中心;唐山工業職業技術學院;
【基金】:國家自然科學基金項目(51208171) 河北省科技支撐計劃項目(13273809)
【分類號】:TU378.4;TU352.11
【相似文獻】
相關期刊論文 前10條
1 劉建偉;李英民;楊治洪;鄭清;;平面RC框架夾心節點與傳統節點抗震性能對比試驗[J];建筑結構;2009年04期
2 吳濤,李紅星,朱佳寧,白國良;鋼筋混凝土框架異型節點抗震性能的試驗研究及設計計算方法[J];建筑科學;2003年04期
3 劉建偉;李英民;楊治洪;夏洪流;單亮;;空間RC框架夾心節點與傳統節點抗震性能對比試驗[J];工業建筑;2009年02期
4 秦新剛;改善框架節點抗震性能方法的研究[J];江蘇建筑;1994年03期
5 王力;閆世杰;鄭圓;張成龍;;鋼-混凝土組合梁鋼框架節點抗震性能試驗[J];哈爾濱工業大學學報;2014年04期
6 吳濤;邢國華;劉伯權;白國良;黃華;;鋼筋混凝土框架變梁中節點抗震性能試驗研究[J];建筑結構學報;2010年10期
7 崔建宇;車軼;孫建剛;宋玉普;渡邊史夫;;配筋形式對框架頂層角節點抗震性能影響試驗研究[J];建筑結構學報;2010年08期
8 年飛;;淺析影響鋼筋混凝土框架節點抗震性能的若干因素[J];中國商界(下半月);2009年12期
9 劉春陽;李振寶;馬華;韓建強;;鋼筋混凝土框架空間節點抗震性能試驗研究[J];工業建筑;2011年06期
10 郝永昶,李忠獻,周煒,康谷貽,胡慶昌,徐云扉;鋼筋混凝土分體柱框架邊節點抗震性能的試驗研究[J];建筑結構;2002年10期
相關會議論文 前10條
1 洪光;吳轉琴;尚仁杰;;緩粘結預應力混凝土框架邊節點抗震性能試驗研究[A];第十一屆后張預應力學術交流會論文集[C];2011年
2 蔡建國;朱洪進;馮健;;低周反復循環荷載作用下世構體系節點抗震性能試驗研究[A];“發展綠色技術,建設節約結構”——第十四屆全國混凝土及預應力混凝土學術會議論文集[C];2007年
3 程浩德;;考慮剪拉比影響的預應力扁梁內節點抗震性能試驗研究[A];建筑結構高峰論壇——復雜建筑結構彈塑性分析技術研討會論文集[C];2012年
4 顧欣;王巖;;淺析鋼筋混凝土框架節點抗震性能的影響因素[A];土木建筑學術文庫(第14卷)[C];2010年
5 劉海峰;王全;郭濤;;影響鋼筋混凝土框架節點抗震性能的因素[A];土木建筑學術文庫(第11卷)[C];2009年
6 秦新剛;徐明;;P—Δ效應對框架節點抗震性能影響的研究[A];第五屆全國結構工程學術會議論文集(第二卷)[C];1996年
7 陳明;高鵬;;帶墊板的雙肢C形鋼斜節點抗震性能分析[A];第三屆全國鋼結構工程技術交流會論文集[C];2010年
8 施衛星;朱伯龍;楊續義;;上海東方明珠廣播電視塔簡體與環梁節點抗震性能研究[A];第六屆全國結構工程學術會議論文集(第三卷)[C];1997年
9 鄒昀;林暉;馬衛強;;具有自復位功能裝配式框架節點抗震性能的影響因素分析[A];第23屆全國結構工程學術會議論文集(第Ⅲ冊)[C];2014年
10 劉春陽;李振寶;高等利;;鋼筋混凝土框架空間節點抗震性能比較分析[A];第四屆全國建筑結構技術交流會論文集(下)[C];2013年
相關博士學位論文 前4條
1 楊治洪;RC框架夾心節點抗震性能及設計方法研究[D];重慶大學;2010年
2 傅劍平;鋼筋混凝土框架節點抗震性能與設計方法研究[D];重慶大學;2002年
3 楊文偉;管桁結構搭接節點抗震性能研究[D];蘭州理工大學;2012年
4 曾磊;型鋼高強高性能混凝土框架節點抗震性能及設計計算理論研究[D];西安建筑科技大學;2008年
,本文編號:1525355
本文鏈接:http://sikaile.net/jingjilunwen/jianzhujingjilunwen/1525355.html