既有供熱系統改擴建方法研究
[Abstract]:With the development of urbanization in our country, people's demand for heat supply is increasing gradually. The newly-built heating system not only covers a large area, but also has huge investment and difficult economic recovery. In view of the primary network transformation method of the heating network, this paper mainly studies the related problems of the application of the distributed water pump system in the annular heating system. Firstly, it analyzes the economy of the heating system and establishes the economic model of the universality. The pressure distribution of each pipe section in the heat pipe network is expressed by the average specific friction. Based on the universal economic model, the economic model for the distributed pump system in the annular pipe network is established. The formula for calculating the economic specific friction is derived. Secondly, the characteristics of the distributed pump system in the annular pipe network are studied, mainly aiming at the zero in the system. Based on the model and engineering case, the economic specific frictional resistance formula is used to analyze the new ring system project and verify the economy of the economic specific frictional resistance. According to the renovation project of a heating system in Harbin and based on the renovation design process of the existing pipe network, the renovation method of applying distributed water pump system to the loop pipe network in the actual project is explained. The definition, system form and pipe network form of the system are given. Secondly, the restriction conditions of the series single pipe reformation system are studied, and the method of maximum extension calculation is obtained. Finally, according to the specific case, combined with the economic model of heating system, the economic efficiency of the traditional transformation mode and the series single-pipe system transformation mode is compared, and the influence of the connection location between the new heating load area and the new users on the economic efficiency of the system transformation is considered respectively, and the characteristics of this transformation mode are obtained. The way of design and research provides a theoretical basis and decision-making basis for practical projects.
【學位授予單位】:哈爾濱工業大學
【學位級別】:碩士
【學位授予年份】:2017
【分類號】:TU995
【參考文獻】
相關期刊論文 前10條
1 那海濤;方修睦;;分布式水泵系統和傳統方式在某區域熱源應用對比分析研討[J];應用能源技術;2015年09期
2 尹榮杰;;分布式變頻泵供熱系統的運行調節方式[J];區域供熱;2015年01期
3 王中華;楊濤;;基于遺傳算法的區域供冷供熱管網優化設計方法的改進研究[J];建筑節能;2014年06期
4 石兆玉;楊同球;;全網分布式輸配供熱系統的優越性[J];區域供熱;2013年04期
5 趙曉靖;;不同的熱源供熱溫度在多熱源聯網系統中的應用與探討[J];區域供熱;2013年01期
6 王春玲;;集中供熱的現狀及發展趨勢[J];林業科技情報;2012年03期
7 王云琦;;吸收式熱泵機組在城市集中熱網應用的適應性分析[J];區域供熱;2012年02期
8 王們;鄒平華;雷翠紅;;分布式水泵供熱系統零壓差點與輸送功率的關系[J];暖通空調;2011年10期
9 白振宇;段立豐;王磊;孫剛;;分布式循環水泵供暖系統的設計[J];區域供熱;2010年04期
10 姚東文;邱林;;分布式變頻泵供熱系統節能影響因素[J];煤氣與熱力;2010年04期
相關博士學位論文 前1條
1 王海超;多熱源聯合供熱系統調峰方式及綜合優化研究[D];哈爾濱工業大學;2013年
相關碩士學位論文 前10條
1 李振遠;單向環主干線熱水供熱管網調節方式的研究[D];哈爾濱工業大學;2016年
2 林愛玲;雙熱源單向環狀供熱管網運行調節與調度研究[D];哈爾濱工業大學;2015年
3 田野;區域供熱系統聯絡方式和多熱源位置優化的研究[D];哈爾濱工業大學;2015年
4 李秋華;供熱管網熱力可及性及單向環供熱系統相關問題研究[D];哈爾濱工業大學;2014年
5 武磊;單向環主干線管網供熱系統的可靠性研究[D];哈爾濱工業大學;2014年
6 高光洋;分布式熱水集中供熱系統水力特性分析及運行調節[D];山東建筑大學;2014年
7 季明星;熱水供熱梯級混水系統的研究[D];哈爾濱工業大學;2012年
8 雒俐暖;單管供熱系統及其應用研究[D];太原理工大學;2012年
9 馬琳;多熱源環狀管網定壓及運行調節的研究[D];長安大學;2011年
10 張志雄;單管混水直接供熱系統設計方法的研究[D];太原理工大學;2010年
,本文編號:2232338
本文鏈接:http://sikaile.net/jianzhugongchenglunwen/2232338.html