本文選題：OSEK/VDX + 網絡管理��； 參考：《南京理工大學學報》2013年01期

【摘要】：為了提高控制器局域網(Controller area network,CAN)環境下OSEK/VDX直接網絡管理(Network management,NM)系統的開發效率,本文提出了一種CAN網絡管理模擬系統。其通過對經典網絡協議模擬模塊的分析與對CAN總線協議特性的抽象,利用Network Simulator 2實現了對CAN總線協議與網絡拓撲的模擬,并由直接NM模塊實現了網絡管理功能。實驗證明,該模擬系統不僅可生成與真實系統一致的結果,而且可在開發過程中有效地實現對分布式系統統一的參數調整與測試。
[Abstract]:In order to improve the development efficiency of OSEK/VDX Direct Network Management Network (OSEK/VDX) system based on Controller area Network (CAN) environment, a CAN network management simulation system is proposed in this paper. By analyzing the classical network protocol simulation module and abstracting the characteristic of CAN bus protocol, the simulation of CAN bus protocol and network topology is realized by using Network Simulator 2, and the network management function is realized by direct NM module. The experimental results show that the simulation system can not only generate the same results as the real system, but also effectively adjust and test the uniform parameters of the distributed system during the development process.
【作者單位】： 吉林大學計算機科學與技術學院;吉林大學汽車動態模擬國家重點實驗室;中興通訊股份有限公司;
【基金】：國家科技重大專項(2009ZX0 1038-002-001) 國家發改委高新技術發展基金資助項目([2005]637)
【分類號】：TP393.07

【參考文獻】

相關期刊論文 前3條

1 陳筠翰;秦貴和;于赫;黃s，

本文編號：1959712