發布時間：2019-03-04 09:58

【摘要】：目的分析自力式密封方式在摩擦系數、流體壓力及密封間隙大小的作用下對密封圈的應力及等效壓力的影響.方法利用ABAQUS軟件建立O形密封圈對稱模型,分析在不同的摩擦系數、不同密封間隙及流體壓力下對應力及等效壓力的影響.結果當摩擦系數大于0.3 MPa時,O形密封圈的應力及等效壓力不再受摩擦系數的影響;O形密封圈的應力及等效壓力將隨著流體壓力的增加而增加,但當流體壓力大于2.0 MPa以后,O形密封圈的應力及等效壓力分布及數值幾乎無影響;間隙增大時應力分布區域增加,應力值也增大,等效壓力逐漸降低.結論流體壓力、摩擦系數對O型密封圈應力及等效壓力的影響較大,密封間隙大小對密封圈的應力及等效壓力也有影響.此結論在理論指導和實際應用上具有重要意義.
[Abstract]:Aim to analyze the effect of self-operated seal on the stress and equivalent pressure of seal ring under the action of friction coefficient, fluid pressure and seal clearance. Methods the symmetry model of O-ring was established by ABAQUS software, and the effects of friction coefficient, seal clearance and fluid pressure on stress and equivalent pressure were analyzed. Results when the friction coefficient is greater than 0.3 MPa, the stress and equivalent pressure of the O-ring are no longer affected by the friction coefficient. The stress and equivalent pressure of O-ring will increase with the increase of fluid pressure, but when the fluid pressure is more than 2.0 MPa, the stress and equivalent pressure distribution and value of O-ring will have little effect. When the gap increases, the stress distribution area increases, the stress value increases, and the equivalent pressure decreases gradually. Conclusion the influence of fluid pressure and friction coefficient on the stress and equivalent pressure of O-type sealing ring is great. The sealing clearance also has an effect on the stress and equivalent pressure of sealing ring. This conclusion is of great significance in theoretical guidance and practical application.
【作者單位】： 沈陽建筑大學市政與環境工程學院;
【基金】：國家十二五科技重點項目(2013BAJ15B06-02)
【分類號】：TB42
，

本文編號：2434174