發布時間：2018-09-12 08:02

【摘要】：目的驗證OSB板材能否用于托盤的制作,以及OSB板托盤在叉舉過程中的應力應變情況。方法通過Solid Edge建立使用鋼釘模型進行連接的OSB板托盤模型,并使用軟件內的NX Nastran仿真模塊對托盤模型進行有限元分析,得出托盤叉舉工況下的應力應變分布圖,同時對OSB板托盤進行叉舉試驗。結果通過對OSB板托盤進行有限元仿真分析和實際實驗,得出在6.5 k N載荷下,仿真分析的最大變形量為16.75 mm,實際實驗的最大變形量為18.2 mm,兩者數值近似,驗證了有限元分析的有效性。結論確認了OSB板托盤的實用性,以及在托盤設計階段使用有限元法對托盤性能進行分析驗證與優化的可行性。
[Abstract]:Aim to verify whether OSB plate can be used in the manufacture of pallet and the stress and strain of OSB plate tray in the process of fork lifting. Methods the OSB tray model connected by steel nail model was established by Solid Edge, and the finite element analysis of the pallet model was carried out by using the NX Nastran simulation module in the software, and the stress and strain distribution diagram of the tray under the condition of fork lifting was obtained. At the same time, the fork lift test was carried out on the OSB tray. Results through the finite element simulation analysis and actual experiment of OSB plate tray, it is concluded that under 6.5 KN load, the maximum deformation value of simulation analysis is 16.75 mm, and the maximum deformation amount of actual experiment is 18.2 mm,. The validity of finite element analysis is verified. Conclusion the practicability of OSB tray is confirmed, and the feasibility of using finite element method to analyze and optimize the performance of the tray in the design stage of the tray is verified.
【作者單位】： 陜西科技大學;
【分類號】：TB48
，

本文編號：2238403