本文選題：電流反饋 + 模擬電感�。� 參考：《組合機床與自動化加工技術》2017年09期

【摘要】：傳統的壓電分流阻尼系統控制振動一般采用電壓反饋運算放大器來實現。為了提高壓電分流阻尼系統的控制效果,提出新的基于電流反饋運算放大器的壓電分流阻尼系統設計方法。以根部對位粘貼壓電陶瓷片的兩端固支梁結構為例,根據電流模理論設計了相應的分流電路。針對該結構的第三階固有頻率進行實驗研究和分析,通過改變分流電路中的等效電感和等效電阻大小使其獲得最佳控制效果,并與傳統的基于電壓運算放大器的壓電分流阻尼系統進行對比。實驗結果表明:采用新設計的控制系統抑制振動的效果比傳統的控制系統抑制振動的效果提高了約8%。
[Abstract]:The traditional piezoelectric shunt damping system usually uses voltage feedback operational amplifier to control vibration. In order to improve the control effect of piezoelectric shunt damping system, a new design method of piezoelectric shunt damping system based on current feedback operational amplifier is proposed. Based on the current mode theory, a shunt circuit is designed based on the two ends clamped beam structure of the piezoelectric ceramic plate with the root opposite position as an example. The third order natural frequency of the structure is experimentally studied and analyzed. The optimal control effect is obtained by changing the equivalent inductance and equivalent resistance in the shunt circuit. And compared with the traditional piezoelectric shunt damping system based on voltage operational amplifier. The experimental results show that the vibration suppression effect of the newly designed control system is about 8% higher than that of the traditional control system.
【作者單位】： 南昌航空大學飛行器工程學院;
【基金】：國家自然基金項目(11464031,51265037) 航空科學基金項目(2015ZA56002) 江西省高�？萍悸涞赜�(jì)劃資助項目(KJLD12075) 江西省研究生創新專項資金項目(YC2016-S336)
【分類號】：TB535;TG502.36

【相似文獻】

相關期刊論文 前1條

1 范德民;自動雙頭鋸銑設備氣—液阻尼系統典型故障分析[J];機械工人.冷加工;2002年03期

，

本文編號：1892019