組合式空調機組加濕器噴桿安裝位置和噴嘴朝向?qū)訚裥Ч挠绊懷芯?/H1>
發布時間：2018-05-05 04:45
本文選題：加濕 + 噴桿位置��； 參考：《流體機械》2017年08期
【摘要】：電陶瓷加濕器噴桿安裝位置和噴嘴朝向?qū)訚裥Ч挠绊憜栴}進行了探討。以數值模擬為基礎通過計算流體力學軟件Fluent對送回風管路及噴桿近壁處靜壓分布進行研究,理論分析加濕的可能性,并就分析結果的準確性加以試驗驗證。結果表明:(1)噴桿置于回風管中,噴嘴順流布置和噴嘴逆流布置均可實現加濕目的。噴嘴順流布置時,隨著溫度的升高相對濕度由68.7%升高到82%。噴嘴逆流布置時,隨著溫度的升高相對濕度由61.7%升高到74.6%;(2)噴桿置于送風管路,當加濕器內沒有附加壓力時,由于近壁處的高壓作用在傳統加濕器包括電陶瓷加濕器內產生的處于微小正壓狀態下的蒸汽將無法噴入送風氣流,幾乎達不到加濕目的。
[Abstract]:The influence of installation position of injection rod and nozzle orientation on humidification effect of electric ceramic humidifier is discussed. Based on the numerical simulation, the static pressure distribution of the return air pipeline and the jet rod near the wall was studied by the computational fluid dynamics software Fluent, the possibility of humidification was analyzed theoretically, and the accuracy of the analysis results was tested and verified. The results show that the nozzle downstream arrangement and the nozzle countercurrent arrangement can achieve the purpose of humidification. The relative humidity increased from 68.7% to 822 when the nozzle was arranged downstream. When the nozzle countercurrent is arranged, the relative humidity increases from 61.7% to 74.6% with the increase of temperature) the injection rod is placed in the air supply line, when there is no additional pressure in the humidifier, Because of the high pressure near the wall in the traditional humidifier, including the electric ceramic humidifier, the steam produced under the small positive pressure will not be injected into the air flow, which can hardly achieve the purpose of humidification.
【作者單位】： 天津商業大學教育部制冷技術工程研究中心天津市制冷技術重點實驗室天津市制冷技術工程中心;
【基金】：天津市高等學校科技發展基金計劃項目(20120910)
【分類號】：TB657.2
，
本文編號：1846286
本文鏈接：http://sikaile.net/guanlilunwen/gongchengguanli/1846286.html
本文選題：加濕 + 噴桿位置��； 參考：《流體機械》2017年08期
【摘要】：電陶瓷加濕器噴桿安裝位置和噴嘴朝向?qū)訚裥Ч挠绊憜栴}進行了探討。以數值模擬為基礎通過計算流體力學軟件Fluent對送回風管路及噴桿近壁處靜壓分布進行研究,理論分析加濕的可能性,并就分析結果的準確性加以試驗驗證。結果表明:(1)噴桿置于回風管中,噴嘴順流布置和噴嘴逆流布置均可實現加濕目的。噴嘴順流布置時,隨著溫度的升高相對濕度由68.7%升高到82%。噴嘴逆流布置時,隨著溫度的升高相對濕度由61.7%升高到74.6%;(2)噴桿置于送風管路,當加濕器內沒有附加壓力時,由于近壁處的高壓作用在傳統加濕器包括電陶瓷加濕器內產生的處于微小正壓狀態下的蒸汽將無法噴入送風氣流,幾乎達不到加濕目的。
[Abstract]:The influence of installation position of injection rod and nozzle orientation on humidification effect of electric ceramic humidifier is discussed. Based on the numerical simulation, the static pressure distribution of the return air pipeline and the jet rod near the wall was studied by the computational fluid dynamics software Fluent, the possibility of humidification was analyzed theoretically, and the accuracy of the analysis results was tested and verified. The results show that the nozzle downstream arrangement and the nozzle countercurrent arrangement can achieve the purpose of humidification. The relative humidity increased from 68.7% to 822 when the nozzle was arranged downstream. When the nozzle countercurrent is arranged, the relative humidity increases from 61.7% to 74.6% with the increase of temperature) the injection rod is placed in the air supply line, when there is no additional pressure in the humidifier, Because of the high pressure near the wall in the traditional humidifier, including the electric ceramic humidifier, the steam produced under the small positive pressure will not be injected into the air flow, which can hardly achieve the purpose of humidification.
【作者單位】： 天津商業大學教育部制冷技術工程研究中心天津市制冷技術重點實驗室天津市制冷技術工程中心;
【基金】：天津市高等學校科技發展基金計劃項目(20120910)
【分類號】：TB657.2
，
本文編號：1846286
本文鏈接：http://sikaile.net/guanlilunwen/gongchengguanli/1846286.html
最近更新
教材專著
