本文選題：多品種小批量　切入點：設施布局　出處：《重慶大學》2014年碩士論文　論文類型：學位論文

【摘要】：科學合理的車間設施布局方案評價，有助于發現設施布局方案存在的問題和不足，指導設施布局方案的順利實施。通過對多品種小批量生產車間設施布局研究現狀的分析發現，目前針對多品種小批量生產車間設施布局方案評價的研究較為欠缺，針對評價體系的研究更是匱乏，并且現有的評價方法有一定的局限性。文章提出構建多品種小批量生產車間設施布局方案的評價指標體系，并采用G-TOPSIS法（灰色關聯分析理想點法，Grey Relational Analysis and Technique forOrder Preference by Similarity to an Ideal Solution）建立評價模型，以期豐富多品種小批量生產車間設施布局方案評價的理論基礎，提高設施布局方案評價結果的可靠性。 論文的研究工作主要包括如下幾個方面： 首先，介紹論文的選題背景，剖析國內外設施布局方案評價的研究現狀，提出論文研究的目的及意義，介紹論文研究的主要內容、章節安排。結合多品種小批量生產車間設施布局的基本內涵，深入分析其設施布局的特征，在此基礎上從研究思路和技術路線、研究過程模型、關鍵問題及研究框架四方面提出論文研究的技術框架。 其次，構建多品種小批量生產車間設施布局方案的評價指標體系。在分析多品種小批量生產車間設施布局影響因素的基礎上，確定評價指標，設計評價指標體系。并基于粗糙集理論刪除冗余指標，，介紹指標約簡的方法。 然后，建立多品種小批量生產車間設施布局方案的評價模型。采用灰色關聯度的方法來確定指標權重；分別分析灰色關聯分析與TOPSIS法在評價應用中存在的問題和不足，利用兩者相結合的方法建立G-TOPSIS的多品種小批量生產車間設施布局方案評價模型。 最后，將上述評價指標體系及評價模型應用于D企業某多品種小批量生產車間的設施規劃項目中，結果表明論文研究成果具有一定的工程應用價值。
[Abstract]:Scientific and reasonable evaluation of workshop facility layout scheme is helpful to find out the problems and shortcomings of the facility layout scheme and to guide the smooth implementation of the facility layout scheme. Through the analysis of the present situation of the research on the facility layout of multi-variety and small-batch production workshop, it is found that, At present, the research on the evaluation of facilities layout in multi-variety and small-batch production workshops is relatively deficient, and the research on the evaluation system is even more scarce. And the existing evaluation methods have some limitations. This paper puts forward the evaluation index system to construct the facility layout scheme of multi-variety and small-batch production workshop. The evaluation model is established by using G-TOPSIS (Grey Relational Analysis and Technique forOrder Preference by Similarity to an Ideal solution) in order to enrich the theoretical basis of facility layout evaluation in multi-variety and small-batch production workshop. Improve the reliability of facility layout evaluation results. The research work of the thesis mainly includes the following aspects:. First of all, it introduces the background of the thesis, analyzes the present situation of the evaluation of the layout of facilities at home and abroad, puts forward the purpose and significance of the research, and introduces the main contents of the paper. Chapter arrangement. Combined with the basic connotation of facilities layout of multi-variety and small-batch production workshop, the characteristics of facility layout are analyzed in depth. On the basis of this, the research process model is studied from the perspective of research ideas and technical route. The technical framework of the thesis is put forward in four aspects: the key problems and the research framework. Secondly, the evaluation index system of facility layout scheme of multi-variety and small-batch production workshop is constructed. On the basis of analyzing the influencing factors of facility layout in multi-variety and small-batch production workshop, the evaluation index is determined. The evaluation index system is designed and the method of index reduction is introduced based on rough set theory. Then, the evaluation model of facility layout scheme of multi-variety and small-batch production workshop is established. The grey correlation degree method is adopted to determine the index weight, and the problems and shortcomings of grey correlation analysis and TOPSIS method in evaluation and application are analyzed respectively. The evaluation model of facility layout of multi-variety and small-batch production workshop based on G-TOPSIS is established by combining the two methods. Finally, the above evaluation index system and evaluation model are applied to the facility planning project of a multi-variety and small batch production workshop in D enterprise. The results show that the research results of this paper have certain engineering application value.
【學位授予單位】：重慶大學
【學位級別】：碩士
【學位授予年份】：2014
【分類號】：TB491

【參考文獻】

相關期刊論文 前10條

1 趙川;楊育;曾強;;基于混合遺傳算法的制造車間布局設計[J];重慶理工大學學報(自然科學版);2010年02期

2 錢吳永;黨耀國;熊萍萍;王正新;;基于灰色關聯定權的TOPSIS法及其應用[J];系統工程;2009年08期

3 劉琦,陳瓊,韋司瀅;基于多層灰色關聯度的知識聯盟伙伴選擇模型[J];華中科技大學學報(自然科學版);2004年07期

4 李火生,李志華,鐘毅芳,戴同;生產車間設備布局線性模型及算法研究[J];計算機工程與應用;2002年11期

5 陳洪濤;周德群;黃國良;;基于粗糙集理論的企業效績評價指標屬性約簡[J];計算機應用研究;2007年12期

6 張新敏,韓天淵;齒輪車間物流分析與設備布置[J];機械設計與制造;2005年04期

7 陳曉慧;楊X;;基于模糊神經網絡模型的企業設施布置評價方法[J];價值工程;2008年06期

8 陳雷,王延章;基于熵權系數與TOPSIS集成評價決策方法的研究[J];控制與決策;2003年04期

9 向號;李明;嚴興全;;基于SLP的生產車間物流優化設計[J];煤礦機械;2007年12期

10 李倍;任建平;鄭德清;;設施布置評價體系的層次化變權綜合分析[J];煤礦機械;2010年12期

相關博士學位論文 前1條

1 鄭曉軍;生產車間設施布局優化方法研究[D];大連理工大學;2010年

本文編號：1648935