【摘要】：以含鐵裝飾原紙生產廢水污泥為原料,NaClO3為氧化劑,經過酸溶和氧化過程,制得了液體聚合硫酸鐵(PFS)絮凝劑。研究了酸溶過程中反應溫度及時間對鐵溶出率的影響。以Fe2+含量表征PFS質量,考察了NaClO3用量、氧化時間和溫度對PFS質量的影響。研究結果表明,酸溶過程中適宜的反應條件為反應5 h,反應溫度80~90℃;NaClO3氧化制備PFS的適宜條件為:n(NaClO3)∶n(Fe2+)=0.18∶1,反應時間3 h。制得的PFS各項指標均符合GB14591—2006中規定的PFS一級標準要求,PFS對造紙廢水的絮凝效果優于市售PFS和PAC,適宜用量為30~45 mg/L;對制藥廢水的絮凝效果與市售PFS無顯著差別,適宜用量為20~30 mg/L。
[Abstract]:Liquid polymerized ferric sulfate (PFS) flocculant was prepared by acid dissolution and oxidation of wastewater sludge from decorative paper with iron as raw material and NaClO3 as oxidant. The effect of reaction temperature and time on iron dissolution rate during acid dissolution was studied. The mass of PFS was characterized by Fe2 content. The effects of NaClO3 dosage, oxidation time and temperature on the quality of PFS were investigated. The results showed that the optimum reaction conditions were 5 h, 80 鈩，

本文編號：2451271