本文關鍵詞： 木質裝飾薄板 干燥特性 干燥變形 干燥基準　出處：《西北林學院學報》2007年04期 　論文類型：期刊論文

【摘要】：本文研究了厚度3mm和5mm的鐵杉、椴木、擬赤楊三種木質裝飾薄板的干燥特性和干燥工藝,篩選出了較優的干燥基準。試驗結果表明:薄板的變形與溫度、薄板的終含水率和薄板尺寸有關。同等情況下,溫度越高,薄板變形越大;薄板的終含水率越低,其變形程度越大;薄板的厚度越小越易發生變形,薄板的寬度越大,其變形程度越大,長度對變形的影響不是很大;加壓可明顯減小總變形值,通過薄板局部加壓和噴蒸聯合處理可有效控制裝飾薄板的干燥質量。
[Abstract]:In this paper, the drying characteristics and drying process of 3 mm and 5 mm thick hemlock, Linden and aldenia wood decorative sheets were studied, and the better drying datum was selected. The results showed that the deformation and temperature of the thin plates were different from each other. The final moisture content of the thin plate is related to the size of the thin plate. At the same time, the higher the temperature, the greater the deformation of the thin plate; the lower the final moisture content of the thin plate, the greater the degree of deformation; the smaller the thickness of the thin plate, the easier it is to deform, and the larger the width of the thin plate is. The greater the degree of deformation, the less the influence of length on the deformation, and the less the total deformation value can be reduced by compression, and the drying quality of decorative thin plate can be effectively controlled by the combination of local pressure and jet steam treatment.
【作者單位】： 南京林業大學干燥技術研究所 河北農業大學林學院 南京林業大學干燥技術研究所 河北農業大學林學院
【基金】：國家林業局“948”項目：單板對流加熱干燥關鍵技術引進(011020111)
【分類號】：TS652

【相似文獻】

相關期刊論文 前10條

1 姚公弼;;干燥作業中一些參數的測定方法[J];醫藥工程設計;1980年05期

2 趙立;;芬，

本文編號：1505795