基于SLALOM的高速光串并轉換技術研究
發布時間：2019-01-06 18:04
【摘要】：當前光網絡中傳輸能力和交換能力的不匹配已經嚴重影響其進一步應用。而利用全光串并轉換器(All-Optical Serial-to-Parallel Converter,AOSPC)將高速串行的光信號轉換為多路低速并行的光信號,然后再進行處理和交換是一種有效的解決方案。由于具有響應速度快、易集成、穩定度高等優點,半導體光放大器環路鏡(Semiconductor Laser Amplifier in a Loop Mirror,SLALOM)已經得到了越來越多的關注。本文以SLALOM為研究基礎,開展了全光域內的串并轉換相關技術研究,并取得了如下研究成果:首先,在分析半導體光放大器(Semiconductor Optical Amplifier,SOA)工作特性的基礎上,提出了一種基于SLALOM的級聯型AOSPC。該方案采用級聯SLALOM的結構,以上一級SLALOM的輸出作為下一級SLALOM的輸入,將各級SLALOM之間的傳播延遲設置為輸入信號的比特周期,通過設置控制光與信號光之間的時序,實現光開關的窗口的周期性打開,以此完成各級SLALOM光脈沖的并行輸出。在仿真軟件Optiwave中實現了利用1?10光串并轉換器將80Gb/s高速串行光信號轉換為10路8Gb/s并行輸出信號。Optiwave仿真結果表明輸出信號眼圖張開度好,且1×10 AOSPC的端口接收靈敏度差異小于10dB。其次,針對級聯型AOSPC中噪聲累積導致輸出信號質量惡化的問題,提出了一種基于SLALOM的混合型AOSPC,該方案采用由M行、N列SLALOM搭建的串并混合結構,可以實現1路信號到M?N路信號的串并轉換。仿真實現了利用4?4的混合型AOSPC將80Gb/s高速串行光信號得到16路5Gb/s并行輸出信號。該方案的優點在于在保證輸出信號質量的前提下,提高了串并轉換結構輸出端口的可擴展性。最后,提出了一種基于Add-Drop型微環諧振腔的級聯型AOSPC,它通過串聯N個Add-Drop型微環諧振腔組成級聯型AOSPC,并在微環諧振腔之間加入與輸入信號傳輸速率相關的傳播延時,并設置泵浦光脈沖信號的周期為串行輸入信號脈沖間隔的N倍,通過控制泵浦光脈沖的到來,實現N路并行信號的輸出。在仿真軟件VPI中實現了利用1?4光串并轉換器將10Gb/s串行光信號轉換為4路2.5Gb/s并行輸出信號,且輸出信號消光比為10dB。最后進行了Add-Drop型微環諧振腔的光開關實驗,為其AOSPC方案提供了實驗依據。
[Abstract]:The mismatch of transmission capacity and switching capacity in optical networks has seriously affected its further application. It is an effective solution to convert high speed serial optical signal into multichannel low speed parallel optical signal by all optical series-parallel converter (All-Optical Serial-to-Parallel Converter,AOSPC), and then process and exchange it. Semiconductor optical amplifier loop mirror (Semiconductor Laser Amplifier in a Loop Mirror,SLALOM) has attracted more and more attention due to its advantages of fast response, easy integration and high stability. Based on the research of SLALOM, the related techniques of series-parallel conversion in optical domain are studied in this paper, and the following research results are obtained: firstly, based on the analysis of the characteristics of semiconductor optical amplifier (Semiconductor Optical Amplifier,SOA), A cascade AOSPC. based on SLALOM is proposed. In this scheme, the structure of cascaded SLALOM is adopted, and the output of SLALOM is used as the input of the next SLALOM. The propagation delay between the SLALOM at all levels is set as the bit period of the input signal, and the timing between the light and the signal light is controlled by setting the time sequence. The window of optical switch is opened periodically so that the parallel output of SLALOM optical pulse at all levels can be completed. In the simulation software Optiwave, the high speed serial optical signal of 80Gb/s is converted into 10 parallel output signals of 8Gb/s by using 1 / 10 optical series-parallel converter. The Optiwave simulation results show that the output signal has good eye opening. The sensitivity difference of 1 脳 10 AOSPC port is less than 10 dB. Secondly, aiming at the problem that noise accumulation in cascaded AOSPC leads to the deterioration of output signal quality, a hybrid AOSPC, scheme based on SLALOM is proposed. The scheme adopts a series-parallel hybrid structure constructed from M-row, N-column SLALOM. It can realize the serial parallel conversion from 1 channel signal to Mon N channel signal. The 16 parallel output signals of 80Gb/s are obtained by using the 80Gb/s high speed serial optical signal using the hybrid AOSPC of 4 + 4. The advantage of this scheme is that the extensibility of the output port is improved under the premise of guaranteeing the output signal quality. Finally, a cascade AOSPC, based on Add-Drop microring resonator is proposed, which is composed of cascaded AOSPC, via N Add-Drop microring resonators in series, and the propagation delay related to the transmission rate of the input signal is added between the microring resonators. The period of the pump pulse signal is N times of the pulse interval of the serial input signal. By controlling the arrival of the pump light pulse, the output of the N channel parallel signal is realized. In the simulation software VPI, the serial optical signal of 10Gb/s is converted into four parallel output signals of 2.5Gb/s by using 1 / 4 optical series-parallel converter, and the extinction ratio of output signal is 10 dB. Finally, the optical switch experiment of Add-Drop microring resonator is carried out, which provides the experimental basis for its AOSPC scheme.
【學位授予單位】：電子科技大學
【學位級別】：碩士
【學位授予年份】：2015
【分類號】：TN929.1
本文編號：2403137
[Abstract]:The mismatch of transmission capacity and switching capacity in optical networks has seriously affected its further application. It is an effective solution to convert high speed serial optical signal into multichannel low speed parallel optical signal by all optical series-parallel converter (All-Optical Serial-to-Parallel Converter,AOSPC), and then process and exchange it. Semiconductor optical amplifier loop mirror (Semiconductor Laser Amplifier in a Loop Mirror,SLALOM) has attracted more and more attention due to its advantages of fast response, easy integration and high stability. Based on the research of SLALOM, the related techniques of series-parallel conversion in optical domain are studied in this paper, and the following research results are obtained: firstly, based on the analysis of the characteristics of semiconductor optical amplifier (Semiconductor Optical Amplifier,SOA), A cascade AOSPC. based on SLALOM is proposed. In this scheme, the structure of cascaded SLALOM is adopted, and the output of SLALOM is used as the input of the next SLALOM. The propagation delay between the SLALOM at all levels is set as the bit period of the input signal, and the timing between the light and the signal light is controlled by setting the time sequence. The window of optical switch is opened periodically so that the parallel output of SLALOM optical pulse at all levels can be completed. In the simulation software Optiwave, the high speed serial optical signal of 80Gb/s is converted into 10 parallel output signals of 8Gb/s by using 1 / 10 optical series-parallel converter. The Optiwave simulation results show that the output signal has good eye opening. The sensitivity difference of 1 脳 10 AOSPC port is less than 10 dB. Secondly, aiming at the problem that noise accumulation in cascaded AOSPC leads to the deterioration of output signal quality, a hybrid AOSPC, scheme based on SLALOM is proposed. The scheme adopts a series-parallel hybrid structure constructed from M-row, N-column SLALOM. It can realize the serial parallel conversion from 1 channel signal to Mon N channel signal. The 16 parallel output signals of 80Gb/s are obtained by using the 80Gb/s high speed serial optical signal using the hybrid AOSPC of 4 + 4. The advantage of this scheme is that the extensibility of the output port is improved under the premise of guaranteeing the output signal quality. Finally, a cascade AOSPC, based on Add-Drop microring resonator is proposed, which is composed of cascaded AOSPC, via N Add-Drop microring resonators in series, and the propagation delay related to the transmission rate of the input signal is added between the microring resonators. The period of the pump pulse signal is N times of the pulse interval of the serial input signal. By controlling the arrival of the pump light pulse, the output of the N channel parallel signal is realized. In the simulation software VPI, the serial optical signal of 10Gb/s is converted into four parallel output signals of 2.5Gb/s by using 1 / 4 optical series-parallel converter, and the extinction ratio of output signal is 10 dB. Finally, the optical switch experiment of Add-Drop microring resonator is carried out, which provides the experimental basis for its AOSPC scheme.
【學位授予單位】：電子科技大學
【學位級別】：碩士
【學位授予年份】：2015
【分類號】：TN929.1
【參考文獻】
相關期刊論文 前3條
1 逄煥剛,何瑾琳,張志遠,孫小菡,張明德;小信號增益及環時間非對稱性對TOAD開關特性的影響[J];東南大學學報(自然科學版);2000年03期
2 謝崇進,葉培大;半導體光放大器的快速飽和效應及其長度對TOAD解復用器性能的影響[J];中國激光;2000年06期
3 帥詞俊,段吉安,苗健宇,鐘掘;光纖耦合器預拉時熔錐區的熱分析[J];中南大學學報(自然科學版);2004年04期
，本文編號：2403137
本文鏈接：http://sikaile.net/kejilunwen/wltx/2403137.html
最近更新
教材專著
