【摘要】：描述了基于放大轉發中繼underlay模式下的D2D傳輸模型,研究了用戶最大發射功率受限前提下利用單向放大轉發中繼的D2D通信系統功率分配方法.首先從D2D系統端到端信干噪比表達出發,推導出D2D鏈路和蜂窩上下行鏈路的可達和速率,據此建立了可達和速率的聯合功率優化模型,根據功率約束條件將雙目標優化模型轉化為單目標優化模型;然后采用Pareto優化方法最大化可達和速率,并提出相應的低復雜度實現算法.仿真結果表明:在中低信噪比區域,基于放大轉發中繼輔助的D2D通信性能顯著優于傳統D2D通信模式,采用Pareto功率優化方法可進一步提升D2D通信以及蜂窩上下行鏈路的系統可達和速率.
[Abstract]:This paper describes a D2D transmission model based on underlay mode for amplifying and forwarding relay, and studies the power allocation method of D2D communication system using one-way amplification relay under the premise of maximum transmit power limitation. Based on the end-to-end signal-to-noise ratio expression of D2D system, the reachability rate of D2D link and cellular uplink and downlink is derived, and the joint power optimization model of reachability sum rate is established. According to the power constraint condition, the two-objective optimization model is transformed into the single-objective optimization model. Then the Pareto optimization method is used to maximize the reachability rate and the corresponding low complexity algorithm is proposed. The simulation results show that the performance of D2D communication based on amplifying and forwarding relay is better than that of traditional D2D communication mode in the low signal-to-noise ratio region. Using Pareto power optimization method can further improve the system reachability and rate of D2D communication and cellular uplink and downlink.
【作者單位】： 南京郵電大學江蘇省無線通信重點實驗室;
【基金】：國家科技重大專項基金(No.2011ZX03005-004-03) 國家“973”重點基礎研究發展計劃基金(No.2013CB329005) 國家自然科學基金(No.61171093) 江蘇省優勢學科建設項目基金(No.YX002001)資助
【分類號】：TN929.5

【相似文獻】

相關碩士學位論文 前2條

1 李玉兵;未來移動通信系統中的D2D關鍵技術研究[D];電子科技大學;2012年

2 皮愛霞;LTE系統下D2D多播重傳技術研究[D];西安電子科技大學;2014年

，

本文編號：2361298