本文選題：TD-SCDMA + 物理層��； 參考：《電子科技大學》2014年碩士論文

【摘要】：軟件無線電與傳統無線電相比,具有硬件模塊化、標準化,軟件可重構、可編程等優勢。因此,可以在軟件無線電標準硬件平臺上通過軟件編程實現各種通信功能。TD-SCDMA是具有中國自主知識產權的移動通信技術,也是當今主流的3G標準之一,已經在商用中取得了成功。因此在軟件無線電平臺上開發TD-SCDMA波形具有現實意義。為此,論文采用自主研發的軟件無線電平臺(uSDR),對TD-SCDMA物理層波形進行開發與實現,具體工作如下:首先,分析了TD-SCDMA標準協議中的物理層部分,在協議研究的基礎上對TD-SCDMA物理層波形進行目標分析,包括約束條件、設計目標和總體結構三個方面;其次,從工程實現的角度研究了物理層關鍵技術,包括直接序列擴頻、上下變頻、時間同步和信道估計。給出了波形的設計方案,從發射機和接收機兩個方面對波形進行設計和仿真,其中,整體仿真在信噪比為8.0dB時誤碼率已降至10-3,滿足語音通信的基本要求;最后,根據波形設計方案使用System Generator工具實現波形并對波形進行驗證。實現部分給出了收發兩端單元的信號描述、單元內部流程和單元間連接關系。驗證部分通過功能模塊驗證和文件傳輸驗證驗證功能,通過誤比特率驗證和資源占用分析來評估性能。其中,誤比特率驗證結果比仿真低1.5dB。論文在軟件無線電平臺上設計并實現了TD-SCDMA物理層波形。提供了TD-SCDMA技術和軟件無線電技術學習、實踐的平臺,可用于高等院�；蚩蒲袡C(jī)構教學實驗。同時豐富了軟件無線電平臺的波形功能,為之后在軟件無線電平臺上進行更加復雜的波形開發提供了參考。
[Abstract]:Compared with traditional radio, software radio has the advantages of hardware modularization, standardization, software reconfigurable and programmable. Therefore, it is the mobile communication technology with Chinese independent intellectual property that can realize various communication functions by software programming on the hardware platform of software radio standard. It is also one of the mainstream 3G standards and has been successfully used in commercial applications. Therefore, it is of practical significance to develop TD-SCDMA waveform on software radio platform. Therefore, the paper develops and implements the physical layer waveform of TD-SCDMA by using the software radio platform (uSDR), which is developed by ourselves. The specific work is as follows: firstly, the physical layer part of TD-SCDMA standard protocol is analyzed. On the basis of protocol research, the target analysis of TD-SCDMA physical layer waveform is carried out, including constraint condition, design target and overall structure. Secondly, the key technology of physical layer, including direct sequence spread spectrum, is studied from the point of view of engineering implementation. Up-down conversion, time synchronization and channel estimation. The design scheme of waveform is given, and the waveform is designed and simulated from two aspects of transmitter and receiver. The overall simulation reduces the bit error rate to 10-3 when the SNR is 8.0dB, which meets the basic requirements of voice communication. According to the waveform design scheme, the system Generator tool is used to realize the waveform and verify the waveform. In the realization part, the signal description, the flow inside the unit and the connection between the units are given. The verification part evaluates the performance through function module verification and file transfer verification function, error bit rate verification and resource occupancy analysis. The result of error bit rate verification is 1.5 dB lower than that of simulation. In this paper, the physical layer waveform of TD-SCDMA is designed and implemented on the software radio platform. TD-SCDMA technology and software radio technology learning, practice platform, can be used in colleges and universities or scientific research institutions teaching experiments. At the same time, it enriches the waveform function of the software radio platform, and provides a reference for the development of more complex waveform on the software radio platform.
【學位授予單位】：電子科技大學
【學位級別】：碩士
【學位授予年份】：2014
【分類號】：TN929.53

【參考文獻】

相關期刊論文 前1條

1 吳文華;曾德明;;移動通信產業技術標準形成機制比較及啟示[J];科技進步與對策;2006年08期

相關碩士學位論文 前1條

1 郭俊位;USDR平臺中FPGA圖形化設計關鍵技術研究[D];電子科技大學;2013年

，

本文編號：2092017