東仁溝注水示范區綜合治理方案
[Abstract]:In the Dongrengou oil area of Dingbian Oil production Plant, five reservoirs, C1-C _ 3N _ 4 _ 4 _ 5 and C _ 6-C _ 8, have the characteristics of thin monolayer, low porosity, low permeability, low reservoir pressure and strong heterogeneity between layers, etc. For a long time, they are mainly used in open-hole completion. Depending on the natural energy for oil production, the pressure decreases rapidly, the natural energy deficit in oil area is serious, the total oil production is low, and the reservoir development effect is poor. In order to develop the reservoir efficiently, the whole water injection development was carried out in the study area, but the production changed little and the water cut increased rapidly. Therefore, it is urgent to analyze the water injection performance and the high efficiency development technology in the study area. In this paper, the reservoir characteristics and geological characteristics in the study area are analyzed and studied firstly, secondly, the single well productivity, the change of water cut and the decline rule of oil well production are studied through the dynamic data of existing wells, and the system of injection-production and well pattern is analyzed and studied. Thirdly, the situation of water injection in the study area is analyzed, the effect of water injection and the condition of water injection utilization are analyzed and studied, the production degree of water drive reserves is calculated, and the final oil recovery in the study area is analyzed and forecasted in combination with the actual situation. The reasonable water injection rate, production speed and injection-production ratio in the study area are determined, and the current water injection development effect is comprehensively evaluated. Through these studies, it is considered that the study area belongs to fluvial facies, pore type is mesoporous-fine throat type and medium pore-micro-fine throat type and heterogeneity is strong; By analyzing and forming a set of development and adjustment technology suitable for the formation and development characteristics of oil field, the recovery degree of oil field is increased.
【學位授予單位】:西安石油大學
【學位級別】:碩士
【學位授予年份】:2015
【分類號】:TE357.6
【相似文獻】
相關期刊論文 前10條
1 古莉華;扶詠梅;;超小直徑產液剖面測試儀及其應用[J];江漢石油職工大學學報;2009年06期
2 劉歡樂;吳則鑫;張博;周明;周雅杰;;油田生產制度改變時產液量變化規律預測[J];石油鉆探技術;2013年05期
3 金谷;;低產液井井下故障分析及治理措施[J];中國新技術新產品;2011年13期
4 趙麗平;;薩爾圖油田南部開發區南六-七區鉆停區塊產液量、綜合含水變化特征[J];科技促進發展;2011年S1期
5 姬紅曉,井洪泉,姬建國,吳昊,趙士華;河南油田稠油產液剖面測試技術現場應用及探討[J];油氣井測試;2005年04期
6 李成芹,趙玉賢,周長民,由世江,馬冬嵐;高溫產液剖面測試技術應用[J];特種油氣藏;2000年S1期
7 劉代娥,曾鳳興,葉瑛,常月梅;應用生產參數相關模型進行產液結構調整[J];內蒙古石油化工;2002年02期
8 郭道連;徐加梅;譚德慶;;低產液井油流量測量儀在青海油田的應用[J];石油儀器;2012年01期
9 殷雷;;低產低效井間抽措施的適應性[J];油氣田地面工程;2012年09期
10 鄭力會;李光蓉;;定性判別電潛泵剪切作用造成產液乳化的數值模擬方法[J];石油鉆采工藝;2008年03期
相關重要報紙文章 前4條
1 本報通訊員 王燕 王寧波;張榮強和他的“溫和管理法”[N];中國石油報;2001年
2 王金法 鞠迅;老油田“休養生息”換新顏[N];中國石化報;2003年
3 宋曉瑞;花兒就是這樣紅[N];中國石油報;2004年
4 本報記者 趙士振 通訊員 王震璽;油井避寒“六字訣”[N];中國石化報;2010年
相關碩士學位論文 前8條
1 鄭娟;功圖法在油田單井計量系統中的應用與研究[D];西安石油大學;2015年
2 鐘寶鴻;東仁溝注水示范區綜合治理方案[D];西安石油大學;2015年
3 王嗣穎;基于光纖傳感油藏井下產液剖面監測技術研究[D];哈爾濱工業大學;2013年
4 柴金剛;溢氣型低產液低含水產出剖面測井技術研究[D];東北石油大學;2014年
5 孫遠輝;集選油井產液量自動計量裝置研究開發[D];中國石油大學(華東);2013年
6 管桐;功圖法計算抽油機井產液量的研究[D];長江大學;2014年
7 楊繼波;裸眼井稠油裂縫性油藏產液剖面測井技術研究[D];中國石油大學;2007年
8 范蕊;基于連續式功圖法油井量液系統的應用研究[D];東北石油大學;2014年
,本文編號:2340479
本文鏈接:http://sikaile.net/kejilunwen/shiyounenyuanlunwen/2340479.html