水力空化去除水中石油污染物實驗研究
發布時間:2018-09-11 19:25
【摘要】:采用多孔孔板空化反應器處理石油污水,考察了不同入口壓力、石油初始含量、溫度和空化時間等影響因素對水中石油污染物去除效果的影響。結果表明,當入口壓力為0.30 MPa、溫度為35℃、空化時間為5 h時,水力空化對質量濃度為90 mg/L的石油污水中石油污染物的去除率可達57.68%。氣相色譜-質譜聯用儀分析結果顯示,空化反應5 h后,譜峰數量由原水的25個減少到14個,烷烴占有機物總量由42.37%減少到28.45%,峰面積也由49.36%減少到35.49%。這說明水力空化對水中石油污染物有很好的降解和去除作用。
[Abstract]:The effect of different inlet pressure, initial oil content, temperature and cavitation time on the removal efficiency of petroleum pollutants in water was investigated by using porous plate cavitation reactor. The results show that when the inlet pressure is 0.30 MPa, the temperature is 35 鈩,
本文編號:2237646
[Abstract]:The effect of different inlet pressure, initial oil content, temperature and cavitation time on the removal efficiency of petroleum pollutants in water was investigated by using porous plate cavitation reactor. The results show that when the inlet pressure is 0.30 MPa, the temperature is 35 鈩,
本文編號:2237646
本文鏈接:http://sikaile.net/kejilunwen/shiyounenyuanlunwen/2237646.html
最近更新
教材專著