本文選題：加重壓裂液 + 高溫深井�。� 參考：《鉆井液與完井液》2017年01期

【摘要】：為解決深層破裂壓力高、常規壓裂液難以壓開的難題,開展了加重壓裂液體系研究。由于壓裂液需要進入到儲層深部,因此要求加重劑具有良好的水溶性,而瓜膠壓裂液需要在弱堿性環境中交聯,因此強酸弱堿鹽類加重劑,如氯化鈣、氯化鋅等不適用,溴酸鹽(溴化鉀、溴化鈣等)雖可用但成本較高,難以應用,因此選擇甲酸鹽,該加重壓裂液密度在1.0~1.5g/cm3范圍內可調。受電性、分子量和分散性的影響,助排劑和黏土穩定劑可能與甲酸鹽發生化學反應或物理作用,出現絮凝、析出或沉淀現象,通過實驗優選出ME-1微乳助排劑和FP-2黏土穩定劑,結合流變性、濾失和破膠等實驗,優選了與其配伍的有機硼交聯劑等相關助劑,形成綜合性能良好的加重壓裂液體系。董8井壓裂層段5 353.70~5 364.45 m,地層溫度為120℃,優化加重壓裂液(密度為1.2 g/cm3)現場配制工藝,成功地進行了現場應用;壓后破膠液黏度小于5 m Pa·s,返排率達100%。該加重壓裂液技術為下一步的高閉合應力油藏的壓裂改造提供了經驗。
[Abstract]:In order to solve the problem that deep fracture pressure is high and conventional fracturing fluid is difficult to open, the study of aggravated fracturing fluid system is carried out. Because the fracturing fluid needs to enter the deep reservoir, it is required that the aggrandizer has good water solubility, while the melamine fracturing fluid needs to be crosslinked in the weakly alkaline environment, so the strong acid and weak alkali salts, such as calcium chloride, zinc chloride, etc., are not applicable. Bromate (potassium bromide, calcium bromide, etc.) can be used, but the cost is high, so it is difficult to use formate. Therefore, the density of fracturing fluid can be adjusted in the range of 1.0~1.5g/cm3. Due to the influence of electricity, molecular weight and dispersity, the drainage aid and clay stabilizer may react with formate, flocculate, precipitate or precipitate, and ME-1 microemulsion and FP-2 clay stabilizer can be selected by experiments. Combined with rheology, filtration and gel breaking experiments, organic boron crosslinker and other related additives were selected to form an aggravation fracturing fluid system with good comprehensive properties. The fracturing zone of Dong8 well is 5353.705 364.45 m and the formation temperature is 120 鈩，

本文編號：1885996