本文選題：螺桿鉆具 + 熱老化實驗��； 參考：《計算力學學報》2017年04期

【摘要】：隨著我國油氣資源勘探開發向深部地層邁進,螺桿鉆具定子橡膠井下高溫?zé)崂匣瘑栴}日益凸顯,導致螺桿鉆具輸出性能衰減,嚴重影響鉆進效率,迫切需要揭示熱老化對螺桿鉆具定子橡膠力學性能的影響,以在設計之初提出可減小螺桿鉆具輸出性能衰退的綜合方案。本文開展了螺桿馬達定子橡膠在不同溫度下的熱老化實驗,通過拉伸實驗得出應力應變數據并擬合出Mooney-Rivlin模型常數和Yeoh模型常數;再對所得實驗數據及所求得的模型常數數據進行分析;最后,使用確定了基本常數的模型開展了數值計算。計算結果表明,隨著溫度的上升,Mooney-Rivlin模型常數C_1增大、C_2減小,C_1和C_2呈明顯相反變化的趨勢,Yeoh模型常數C_(10)和C_(20)增大,C_(30)減小;通過模型計算結果與室內實驗測定結果的對比,證明了Mooney-Rivlin模型較Yeoh模型更適合于螺桿馬達定子橡膠的力學分析。不考慮環境溫度熱老化和考慮環境溫度熱老化,螺桿鉆具定子襯套的計算結果存在很大差別,研究工作不僅證明了螺桿鉆具定子橡膠熱老化研究的必要性,更為螺桿鉆具定子橡膠的線型設計和過盈量選取提供了參考。
[Abstract]:With the development of oil and gas resources in China, the problem of high temperature thermal aging in the stator rubber hole of screw drill tool becomes more and more prominent, which results in the attenuation of the output performance of the screw drill tool and seriously affects the drilling efficiency. It is urgent to reveal the influence of thermal aging on the mechanical properties of the stator rubber of the screw drill tool, so as to put forward a comprehensive scheme to reduce the deterioration of the output performance of the screw drill tool at the beginning of the design. The thermal aging experiments of stator rubber of screw motor at different temperatures were carried out in this paper. The stress-strain data were obtained by tensile test and the Mooney-Rivlin model constants and Yeoh model constants were fitted. Then the experimental data and the obtained model constant data are analyzed. Finally, the numerical calculation is carried out by using the model which determines the basic constant. The results show that with the increase of temperature, the Mooney-Rivlin model constant C _ S _ 1 and C _ S _ 2 decrease the trend that the C _ S _ 1 and C _ S _ 2 show a marked opposite change, and the Yeoh model constant C _ (10) and C _ (20) _ (20) increase and increase (C _ (30); the results of the model calculation are compared with the results of the indoor experiment. It is proved that Mooney-Rivlin model is more suitable for mechanical analysis of screw motor stator rubber than Yeoh model. The calculation results of the stator bushing of screw drilling tools are very different without considering the environmental temperature thermal aging and the environmental temperature thermal aging. The research work not only proves the necessity of the research on the thermal aging of the screw drill tool stator rubber. It also provides reference for the design of stator rubber and the selection of interference.
【作者單位】： 西南石油大學機電工程學院;
【基金】：國家自然科學基金(51674214,51604234) 四川省青年科技創新團隊(2017TD0014)資助項目
【分類號】：TE921.2;TQ336.5

【相似文獻】

相關期刊論文 前10條

1 ;塑料熱老化分析方法進展及新酚樹脂熱老化測定[J];云南化工技術;1979年01期

2 石柘;;估算高聚物加速熱老化壽命的新方法[J];上海建材學院學報;1989年01期

3 趙國清;李書波;孫舜華;;膠粘劑熱老化中活化能E與頻率因子A的測定方法[J];哈爾濱科學技術大學科學報告會論文摘要匯編;1985年S1期

4 杜斌;楊睿;謝續明;;聚對苯二甲酸乙二醇酯水熱老化過程中的物理和化學變化[J];塑料;2011年05期

5 ;從防老劑損失研究硫化膠的使用期和貯存期——紫外吸收光譜在熱老化研究中的應用[J];老化通訊;1980年01期

6 Т.Γ.Дегтева;王秀華;;配合劑對壓縮狀態下熱老化時密封耐寒性能的研究[J];橡膠參考資料;1985年03期

7 劉崇進;貝承訓;彭傳正;周小明;林春景;;熱老化橡膠的導熱率的測量和分析[J];合成材料老化與應用;2012年04期

8 喬致雯;;2959、HO68—1硫化橡膠的烘箱加速老化與自然貯存老化[J];合成材料老化與應用;1984年01期

9 周運安;姜鋒;李鑫;王榮民;;聚對苯二甲酰對苯二胺纖維的熱老化行為與機理研究[J];高分子學報;2010年07期

10 趙國清;李書波;孫舜華;蔣忠岳;;J-15膠粘劑熱老化壽命分析[J];哈爾濱科學技術大學學報;1982年01期

相關會議論文 前2條

1 周紅萍;李敬明;韋興文;張偉斌;;F_(2311)熱老化后的性能研究[A];2006年全國高分子材料科學與工程研討會論文集[C];2006年

2 高秀枝;盧立軍;張雪靜;徐廣通;龍軍;;固體NMR結合IR技術研究水熱老化對Y型分子篩的結構和酸性的影響[A];第十七屆全國波譜學學術會議論文摘要集[C];2012年

，

本文編號：1812253