本文選題：鉆井液 + 聚合物��； 參考：《石油化工》2017年01期

【摘要】：采用水溶液聚合引發體系,合成了抗高溫聚合物降濾失劑HR-1�？疾炝嘶鶊F(tuán)比、單體摩爾比、體系p H、總單體用量、交聯劑加量、引發劑加量等條件對HR-1性能的影響;并在淡水基漿和水基鉆井液中對HR-1的性能進行了評價。采用FTIR,TG,DTG等方法對HR-1進行表征。綜合考慮最優合成條件為:基團比為6∶4,單體摩爾比為10∶5,p H8,總單體用量(w)保持在60%~67%,交聯劑加量(w)固定在7.0%~8.5%,引發劑加量(w)為0.3%~0.7%。實驗結果表明,HR-1表現出良好的熱穩定性和降濾失能力,抗溫達270℃,在淡水基漿中HR-1加量為2.0%(w)時,中壓濾失量(FL)由46.0 m L降至7.6 m L;抗溫270℃鉆井液體系高溫穩定性好,流變性易于控制,FL小于4.0 m L,高溫高壓濾失量小于13.0m L。表征結果顯示,反應單體發生了接枝共聚反應,并具有較強的熱穩定性。
[Abstract]:The high temperature polymer filtrate reducer HR-1 was synthesized by aqueous solution polymerization initiator. The effects of group ratio, monomer molar ratio, system pH, total monomer content, crosslinking agent dosage and initiator dosage on the properties of HR-1 were investigated, and the properties of HR-1 were evaluated in fresh water based slurry and water-based drilling fluid. HR-1 was characterized by FTIR TG-DTG. The optimum synthesis conditions are as follows: the molar ratio of group is 6: 4, the molar ratio of monomer is 10: 5p / H 8, the amount of total monomer is kept at 60: 67 and the amount of crosslinking agent is fixed at 7. 0% and 8. 5%, and the amount of initiator is 0. 3% and 0. 7%. The experimental results show that HR-1 has good thermal stability and filtration reduction ability. When the temperature reaches 270 鈩，

本文編號：1809047