本文關鍵詞： 天然氣管道 運行優化 壓縮機功率 擬合函數　出處：《油氣儲運》2017年06期 　論文類型：期刊論文

【摘要】：完成一次大型天然氣管網運行方案優化預計需要數十小時的計算機運算時間,其中絕大部分時間用于壓縮機組功率計算,基于此,提出利用擬合函數簡化壓縮機的功率計算,但該方法未考慮壓縮機進口溫度對功率的影響。為提高擬合精度,引入壓縮機進口溫度對擬合函數加以改進,并以國內某輸氣管道系統配置的3種型號壓縮機為例檢驗其效果。結果表明:改進前的最大偏差在10%以上,而改進后的最大偏差低于5%,平均偏差低于1%。將改進的擬合函數應用于某虛擬管道的工藝運行方案優化過程,其結果與常規方法計算結果的絕對偏差低于0.67 MW,相對偏差低于1.1%,且擬合函數法比常規方法節省了大量計算時間。
[Abstract]:It takes tens of hours of computer operation time to complete the optimization of a large natural gas pipeline network, and most of the time is used to calculate the power of compressor unit. Based on this, it is proposed to simplify the power calculation of compressor by using fitting function. However, the influence of compressor inlet temperature on power is not considered in this method. In order to improve the fitting accuracy, the compressor inlet temperature is introduced to improve the fitting function. The results show that the maximum deviation before improvement is more than 10%, taking three types of compressors installed in a domestic gas pipeline system as an example. The improved maximum deviation is less than 5 and the average deviation is less than 1.The improved fitting function is applied to the optimization process of the process operation plan of a virtual pipeline. The absolute deviation and relative deviation of the results are less than 0.67 MW and 1.1 respectively, and the calculation time of the fitting function method is much less than that of the conventional method.
【作者單位】： 中國石油大學(北京)城市油氣輸配技術北京市重點實驗室;中國石油西南管道公司貴陽輸油氣分公司;中國石油天然氣股份有限公司規劃總院;
【分類號】：TE974

【參考文獻】

相關期刊論文 前5條

1 艾慕陽;柳建軍;李博;刁洪濤;張俊;康陽;;天然氣管網穩態運行優化技術現狀與展望[J];油氣儲運;2015年06期

2 李曉平;李天成;呂勃蓬;全愷;蘇pば，

本文編號：1496775