本文選題：FPGA　切入點：ARINC總線　出處：《計算機測量與控制》2014年06期

【摘要】：提出了在一塊芯片內實現ARINC429總線協議,并將USB、PCI兩種接口結合在一塊接口板上的新構想;并根據板卡的功能和技術指標要求,設計了基于FPGA的ARINC429總線接口板;在硬件設計上采用模塊化方法設計了系統的硬件電路,分析了各部分的功能,并對硬件接口進行了詳細的設計;軟件設計上從硬件和軟件兩方面論述了NIOSⅡ處理器的設計,從總體設計、發送通道、接收通道、接口邏輯等方面設計與實現了多通道總線協議IP核;最后對板卡的功能進行測試,結果表明設計的接口板能夠達到ARINC429數據通信的要求,能夠克服專用芯片中的數據格式固定,使用不夠靈活方便等缺點。
[Abstract]:In this paper, a new idea of implementing ARINC429 bus protocol in one chip and combining two kinds of interfaces in one interface board is proposed, and the ARINC429 bus interface board based on FPGA is designed according to the function and technical requirements of board board.In hardware design, the hardware circuit of the system is designed by modularization method, the functions of each part are analyzed, and the hardware interface is designed in detail, and the design of NIOS 鈪，

本文編號：1729405