發布時間：2018-10-17 19:30

【摘要】：脫脂過程是注射成型工藝中關鍵步驟,生產過程中常常因?yàn)槊撝^程控制不當,引發坯體產生變形、微裂紋、致密度低等問題,并且常規熱脫脂耗時較長,嚴重影響生產效率,增加生產成本。針對上述問題,通過采用溶劑脫脂和熱脫脂相結合的兩步脫脂工藝,研究了脫脂溶劑和脫脂溫度對溶劑脫脂效率的影響,以及兩步脫脂相結合對生產效率和坯體質量的影響,實驗證明采用在60℃汽油脫脂1 h后進行熱脫脂的兩步脫脂工藝可以有效避免坯體變形、微裂紋、不致密等缺陷,并且可以將脫脂過程從原來的25 h縮短至8 h,較大的縮短脫脂周期。
[Abstract]:The degreasing process is a key step in the injection molding process. It is often caused by improper control of the degreasing process, resulting in deformation of the billet, microcracks, low density and so on, and the conventional hot degreasing takes a long time, which seriously affects the production efficiency. Increase production costs. Aiming at the above problems, the effects of degreasing solvent and temperature on the efficiency of solvent degreasing, and the effect of the combination of two steps of degreasing on the production efficiency and the mass of the billet were studied by using the two-step degreasing process of solvent degreasing and thermal degreasing. The experimental results show that the two-step degreasing process with thermal degreasing at 60 鈩，

本文編號：2277724