【摘要】：為了解決等靜壓法制備致密氧化鉻耐火材料過程中產生大量廢棄粉塵的問題,以N,N-二甲基丙烯酰胺(DMAA)為單體,以N,N-亞甲基雙丙烯酰胺(MBAM)為交聯劑,以AN-2000為分散劑,以2,2’-偶氮[2-(2-咪唑啉-2-基)丙烷]鹽酸鹽(AZIP·2HCl)為引發劑,采用凝膠注模工藝制備了致密氧化鉻耐火材料。研究了漿料p H(分別為4、5、6、7、8、9、10)、分散劑AN-2000用量(質量分?jǐn)?shù)分別為0.1%、0.2%、0.3%、0.4%、0.5%)、固相含量(固相體積分?jǐn)?shù)分別為50%、51%、52%、53%)對漿料黏度以及生坯和1 500℃保溫2 h燒后試樣性能和顯微結構的影響。結果表明:漿料中分散劑AN-2000的最佳用量為0.4%(w),最佳p H為8,最佳固相含量為52%(φ)。以最佳條件制備的生坯的相對密度和抗折強度分別為66.7%和4.8 MPa,燒后試樣的相對密度、顯氣孔率和抗折強度分別為85.1%、14.7%和66.7 MPa,生坯和燒后試樣的顯微結構均勻。
[Abstract]:In order to solve the problem of producing a large amount of waste dust in the preparation of dense chromium oxide refractories by isostatic pressing method, NN- dimethylacrylamide (DMAA) was used as monomer, NN- methylene bisacrylamide (MBAM) as crosslinking agent and AN-2000 as dispersant. The dense chromium oxide refractories were prepared by gel injection molding with 2o 2o azo [2- (2 Imidazoline 2 yl) propane] hydrochloride (AZIP 2HCl) as initiator. The effects of the amount of dispersant AN-2000 (0.10%) on the viscosity of slurry and the properties and microstructure of the samples after heat preservation at 1 500 鈩，

本文編號：2243588