【摘要】：提出了一種新的柔性受壓電鑄技術,從理論上深入探討了柔性受壓的作用機理,并通過鎢絲增強鎳的電鑄試驗進行了驗證。理論分析和試驗結果表明:柔性壓緊輪對復合電鑄層的摩擦與擠壓作用可以有效去除復合電鑄層表面的吸附氣泡,獲得表面無缺陷的復合電鑄層;柔性壓緊輪能夠不斷補充電沉積區域的電鑄液,防止復合電鑄層內部出現空洞,并能提高極限電流密度,顯著細化晶粒;柔性受壓條件下獲得的復合電鑄層具有更高的強度,當鎢絲體積分?jǐn)?shù)為50%時,制得的鎢絲-鎳復合電鑄層強度達到1597MPa,提升了21%。
[Abstract]:A new flexible pressure-electroforming technique is proposed. The mechanism of flexible pressure-induced electroforming is discussed theoretically and verified by electroforming experiments of tungsten wire reinforced nickel. The theoretical analysis and experimental results show that the friction and extrusion of the composite electroforming layer by the flexible compaction wheel can effectively remove the adsorption bubbles on the surface of the composite electroforming layer and obtain the composite electroforming layer with no defects on the surface. The flexible compaction wheel can continuously replenish the electroforming fluid in the electrodeposition area, prevent the internal cavity from appearing in the composite electroforming layer, increase the limit current density, and refine the grain significantly, and the composite electroforming layer obtained under the flexible compression condition has higher strength. When the volume fraction of tungsten wire is 50, the strength of tungsten wire-nickel composite electroforming layer is 1597 MPA, which increases 21%.
【作者單位】： 無錫職業技術學院;
【基金】：國家自然科學基金資助項目(51505192) 無錫職業技術學院博士科研啟動基金資助項目(BT2014-05)
【分類號】：TQ153.4

【相似文獻】

相關期刊論文 前1條

1 周園;波紋管機部件易損原因及解決方法[J];工程機械與維修;2004年04期

相關重要報紙文章 前1條

1 趙存耀;熱處理線水淬設備設計與改進[N];世界金屬導報;2011年

，

本文編號：2177991