本文選題：硅溶膠 + 硅酸鋯　； 參考：《陶瓷學報》2017年03期

【摘要】：以硅酸鈉(Na_2SiO_3·9H_2O)和碳酸鋯銨((NH_4)_2ZrO(CO_3)_2)為原料,LiF作礦化劑,采用溶膠-凝膠法制備硅酸鋯粉體。本文研究了制備工藝條件對其合成的影響,并利用X射線衍射(XRD)、掃描電鏡(SEM)等測試手段對實驗樣品進行物相及顯微形貌分析。研究結果表明:在沒有添加礦化劑的情況下,ZrSiO_4的合成溫度高達1100℃左右;而在添加礦化劑LiF的情況下,前驅體經650℃熱處理后,樣品的XRD圖譜開始出現ZrSiO_4的衍射峰,繼續提高熱處理溫度,ZrSiO_4衍射峰強度逐漸提升。當熱處理溫度為750℃時,ZrSiO_4已充分合成,結晶程度良好。
[Abstract]:Zirconium silicate powders were prepared by sol-gel method using Na2SiOster3H _ 2O) and ammonium zirconium carbonate (NH _ 4H _ 4H _ 2O _ 2) as mineralizers and lif as mineralizers. In this paper, the effect of preparation conditions on the synthesis was studied, and the phase and micromorphology of the samples were analyzed by means of X-ray diffraction (XRD) and scanning electron microscopy (SEM). The results show that the synthesis temperature of ZrSiO- 4 is as high as 1100 鈩，

本文編號：1872746