本文選題：抗沖磨混凝土　切入點：抗裂性　出處：《混凝土》2017年09期

【摘要】：基于等強度的配合比設計原則,選定20、30、40、60℃四個養護溫度。前后兩次對活化能進行了測試,對ASTM C1074—04測試方法進行了改進:加密前期測試點和成型后的試件用保鮮膜密封。試驗結果表明:溫度將對膠材的反應造成直接影響,化學反應速率隨著溫度的升高而升高。養護溫度較高時,早期水化程度或強度比養護溫度較低時大,但從長期來看,強度則會小一些,甚至出現強度倒縮現象;抗沖磨混凝土強度開始發展所需最低溫度在1~5℃之間;硅粉和膨脹劑對于提高混凝土的活化能具有一定促進作用。
[Abstract]:Based on the principle of equal strength proportioning design, four curing temperatures were selected.The activation energy of ASTM C1074-04 was tested twice, and the test method of ASTM C1074-04 was improved.The results show that the reaction rate increases with the increase of temperature.When the curing temperature is high, the hydration degree or strength in the early stage is higher than that when the curing temperature is lower, but in the long run, the strength will be smaller, even the strength will shrink, the minimum temperature required for the strength development of the anti-wear concrete is between 1 鈩，

本文編號：1726323