本文關鍵詞： 多孔氮化硅 彎曲強度 密度 燒結溫度　出處：《硅酸鹽學報》2017年06期 　論文類型：期刊論文

【摘要】：采用干壓成型工藝和氣壓燒結方法制備了多孔氮化硅陶瓷。研究了燒結溫度和保溫時間對多孔氮化硅陶瓷顯微結構和力學性能的影響,測定了不同燒結制度下多孔氮化硅陶瓷的氣孔率、物相組成、彎曲強度和彈性模量,分析了多孔氮化硅陶瓷的微觀結構。結果表明:燒結溫度的提高可以促進材料的致密化、α→β-Si_3N_4相轉變和β-Si_3N_4晶粒的生長,提高材料的彎曲強度。在1 900℃燒結溫度條件下,保溫15 min獲得的多孔氮化硅陶瓷的彎曲強度達到106 MPa,同時保留了較高的氣孔率49%。
[Abstract]:Porous silicon nitride ceramics were prepared by dry compression molding and pneumatic sintering. The effects of sintering temperature and holding time on the microstructure and mechanical properties of porous silicon nitride ceramics were studied. The porosity, phase composition, bending strength and elastic modulus of porous silicon nitride ceramics under different sintering conditions were measured. The microstructure of porous silicon nitride ceramics was analyzed. The results show that the increase of sintering temperature can promote the densification of porous silicon nitride ceramics. 鈫捨，

本文編號：1517023