【摘要】：本文以國家基礎技術重大專項《巨型激光驅動器可靠性工程研究與驗證》為背景,針對激光驅動器中最為核心的主放大系統開展系統的可靠性建模與分析技術研究,給出了主放大系統基本可靠性建模與任務可靠性建模的基本原理和方法、部件可靠性建模與分析的一般思路,并以脈沖氙燈為例探索了無部件數據條件下主放大系統部件的可靠性建模與分析技術,最后參考多種理論方法、結合某激光驅動器單束組試驗數據示范了主放大系統可靠性增長分析的主要方法。論文的主要內容包括:(1)緒論。闡述本文的研究背景和意義,分析國內外對主放大系統可靠性建模與分析的研究現狀并給出需要研究的問題及解決思路,展示論文各章節在內容上的邏輯關系。(2)主放大系統可靠性建模與分析。介紹主放大系統的基本結構與工作原理,以可靠性框圖和數學公式為工具,結合實例給出建立主放大系統基本可靠性模型和任務可靠性模型的基本方法和思路,同時系統探討主放大系統部件的經典可靠性建模與分析技術。(3)脈沖氙燈可靠性建模與分析。對脈沖氙燈開展失效物理分析,提出脈沖氙燈試驗數據收集要求,在失效物理分析的基礎上建立脈沖氙燈的可靠性評估模型,最后基于某脈沖氙燈的試驗數據對其進行可靠性建模與分析并驗證模型的適用性。(4)主放大系統可靠性增長分析。參考借鑒多種可靠性增長分析理論,提煉出適合于主放大系統可靠性增長分析的方法,并基于某激光驅動器單束組主放大系統的試驗數據給出主放大系統可靠性增長分析的示例。(5)結束語。對本文所做工作進行總結,指出需要進一步研究和探索的問題。
[Abstract]:In this paper, the reliability modeling and analysis technology of the main amplification system, which is the core of the laser driver, is studied under the background of the national basic technology project "Reliability Engineering Research and Verification of the Giant Laser driver". The basic principles and methods of the basic reliability modeling and task reliability modeling of the main amplification system and the general thinking of component reliability modeling and analysis are given. Taking the pulsed xenon lamp as an example, this paper explores the reliability modeling and analysis technology of the components of the main amplification system under the condition of no component data, and finally refers to many kinds of theoretical methods. The main method of reliability growth analysis of the main amplification system is demonstrated by combining the experimental data of a single beam group of a laser driver. The main contents of this paper are as follows: (1) introduction. This paper expounds the research background and significance of this paper, analyzes the research status of reliability modeling and analysis of the main amplification system at home and abroad, and gives the problems and solutions needed to be studied. The logical relation of each chapter of the thesis is shown. (2) the reliability modeling and analysis of the main amplification system. This paper introduces the basic structure and working principle of the main amplification system. With the aid of the reliability block diagram and mathematical formula, the basic methods and ideas of establishing the basic reliability model and the task reliability model of the main amplification system are given. At the same time, the classical reliability modeling and analysis technology of main amplifier components is discussed systematically. (3) Reliability modeling and analysis of pulse xenon lamp. The failure physics analysis of pulsed xenon lamp is carried out, and the requirement of collecting test data of pulse xenon lamp is put forward. The reliability evaluation model of pulse xenon lamp is established on the basis of failure physics analysis. Finally, based on the experimental data of a pulsed xenon lamp, the reliability modeling and analysis are carried out and the applicability of the model is verified. (4) the reliability growth analysis of the main amplification system. Referring to many kinds of reliability growth analysis theories, the methods suitable for the reliability growth analysis of the main amplification system are abstracted. Based on the experimental data of a single beam group main amplification system of a laser driver, an example of reliability growth analysis of the main amplifier system is given. (5) conclusion. This paper summarizes the work done and points out the problems that need further study and exploration.
【學位授予單位】：國防科學技術大學
【學位級別】：碩士
【學位授予年份】：2015
【分類號】：TN24;TM923.323

【參考文獻】

相關期刊論文 前10條

1 楊澤鋒;莫永鵬;賈申利;劉建軍;李海兵;姚學玲;李興文;;電流尾部截斷對氙燈工作性能影響的實驗研究?[J];強激光與粒子束;2014年09期

2 賈申利;李瑞;劉建軍;李興文;宋曉川;李海兵;;The Plasma Channel Evolution Characteristics of Pulsed Flashlamps Working in an Array[J];Plasma Science and Technology;2013年07期

3 程龍;馮靜;孫權;周經倫;蔡永超;;非連續運行設備貯存-工作聯合退化模型及其應用[J];電子學報;2012年12期

4 彭寶華;周經倫;馮靜;劉學敏;;金屬化膜脈沖電容器剩余壽命預測方法研究[J];電子學報;2011年11期

5 彭寶華;周經倫;劉學敏;;元器件性能退化信息的系統性能可靠性評估[J];火力與指揮控制;2011年10期

6 彭寶華;周經倫;孫權;馮靜;金光;;基于退化與壽命數據融合的產品剩余壽命預測[J];系統工程與電子技術;2011年05期

7 劉學敏;厲海濤;張威;周經倫;周忠寶;;金屬化膜電容器Gamma過程性能退化建模的自助法[J];高電壓技術;2011年01期

8 馬永波;彭述明;龍興貴;符雪梅;曹清薇;楊本福;顏登云;;影響高功率脈沖氙燈壽命的因素[J];強激光與粒子束;2010年10期

9 彭寶華;周經倫;潘正強;;Wiener過程性能退化產品可靠性評估的Bayes方法[J];系統工程理論與實踐;2010年03期

10 彭寶華;周經倫;金光;;綜合多種信息的金屬化膜電容器可靠性評估[J];強激光與粒子束;2009年08期

相關博士學位論文 前1條

1 孫權;神光Ⅲ慣性約束聚變激光裝置可靠性研究[D];國防科學技術大學;2005年

相關碩士學位論文 前3條

1 肖磊;劣化系統維修決策建模與仿真方法研究[D];國防科學技術大學;2008年

2 鐘征;神光-Ⅲ原型裝置放大器系統關鍵元器件可靠性研究[D];國防科學技術大學;2003年

3 趙建印;激光裝置能源系統可靠性研究[D];國防科學技術大學;2002年

，

本文編號：2292771