【摘要】：我國特高壓變電站進線段同塔雙回轉角耐張塔采用剛性跳線,使得地線對跳線端部的保護角偏大,可能增加轉角耐張塔的雷電繞擊風險。為降低雷電繞擊對變電站設備安全的影響,建立了特高壓同塔雙回路耐張轉角塔雷電繞擊先導發展3維模型。通過計算分析地線、跳線和導線最易產生上行先導的位置,獲得了不同線路轉角和地線橫擔長度時,剛性跳線的最大繞擊電流和繞擊閃絡率。結果表明:只需控制地線對相鄰檔距導線的保護角滿足≤ 5°,即可保證剛性跳線單回閃絡率滿足≤0.1次/(100km·a)的要求,而無需對剛性跳線端部的保護角進行控制;SJ322P型桿塔外角側地線橫擔長度可由電氣幾何模型推薦的36 m減小至28 m,內角側地線橫擔長度可由27 m減小至25 m。相關分析結論已應用于1 000 kV錫盟—勝利特高壓交流輸電工程線路防雷設計。
[Abstract]:Rigid jumper is used in the same tower and double rotation angle tensioning tower in UHV substation in our country, which makes the protection angle of the ground wire to the jumper end larger, which may increase the risk of lightning winding of the turret. In order to reduce the influence of lightning wound failure on substation equipment safety, a 3D model for the development of lightning wound failure pilot in UHV tower with double loop tension angle is established. Through the calculation and analysis of the position where the ground wire, jumper wire and wire are most likely to lead up, the maximum current and flashover rate of the rigid jumper wire are obtained when the line rotation angle and the length of the ground wire cross pole are different. The results show that the single flashover ratio of rigid jumper can meet the requirement of 鈮，

本文編號：2176265