發布時間：2018-03-18 17:36

  本文選題：模型預測　切入點：跟蹤誤差　出處：《電機與控制應用》2016年11期 　論文類型：期刊論文

【摘要】：從能量流動角度分析雙PWM結構,在前端整流側采用模型預測算法實現對整流器輸出的有功功率與無功功率最小跟蹤誤差的基礎上,采用動態與靜態相結合的功率補償方法實現對系統能量控制,從而代替前端整流側電壓外環PI控制,用以達到在負載功率突變時抑制直流母線電壓波動,減少直流側電容容量,控制網側諧波的目的。后端采用轉子磁鏈定向控制方法實現對三相異步電動機的控制,最終實現雙PWM前端整流側與后端逆變側的協調控制。仿真結果表明,系統在電動機功率突變時,能夠?qū)崿F(xiàn)功率最小誤差跟蹤控制,并且能夠抑制直流母線電壓波動,網側電流波形良好。
[Abstract]:The dual PWM structure is analyzed from the point of view of energy flow. The model prediction algorithm is used to realize the minimum tracking error of active and reactive power output from the front end rectifier. The dynamic and static power compensation method is used to realize the system energy control instead of the front-end rectifier voltage outer loop Pi control so as to suppress the DC bus voltage fluctuation and reduce the DC side capacitance capacity when the load power changes. The purpose of controlling the harmonics on the network side. The rotor flux oriented control method is used to control the three-phase asynchronous motor at the back end, and the coordination control between the rectifier side of the double PWM front end and the back end inverter side is finally realized. The simulation results show that, When the motor power changes, the system can realize the power minimum error tracking control, and can restrain the DC bus voltage fluctuation, and the grid side current waveform is good.
【作者單位】： 河南科技大學信息工程學院;中信重工機械股份有限公司;
【基金】：國家自然科學基金項目(U1404512)
【分類號】：TM46
，

本文編號：1630613