本文選題：直流漏電流　切入點：磁感應互感器　出處：《華北電力大學》2017年碩士論文　論文類型：學位論文

【摘要】：電力系統中直流供電系統是一個復雜且縱深程度高的系統,測量直流漏電流對于保障電力系統正常運行具有重大意義。磁調制互感器在電力系統中被廣泛用于測量直流漏電流,然而傳統的磁調制互感器算法在測量直流漏電流時并不十分適用。目前針對直流漏電流的測量算法研究較少,且針對溫度對于互感器的影響研究較少。本文針對傳統磁調制互感器算法進行改進,使其適用于測量直流漏電流,并且設計出一款使用改進算法的互感器系統。針對磁芯進行了ANSYS溫度場建模,更好的了解溫度對互感器的影響,并且針對這種影響提出了補償方法。本課題的開展,能夠彌補現有研究的不足,提高現有的直流漏電流測量水平。本文對國內外與本課題相關的研究成果進行分析,對現有的測量直流漏電流的方法進行總結,對測量直流漏電流與現有的相關研究成果進行深入研究,提出合理的測量方法,設計出基于FPGA的直流小電流互感器�；ジ衅鞣譃橛布O(shè)計和軟件設計兩個方面。硬件設計為軟件設計提供了平臺,針對直流漏電流采用差分算法,并且采用雙線圈進行測量,更好的提高了精度。而且由于FPGA所擁有的大量的IO資源,為日后的多路互感器的擴展提供了可能。軟件部分使用了FPGA的內核開發,擁有串口輸出和DA電壓輸出兩種輸出方式,使得互感器的輸出更加直觀。通過實驗數據證明本文所設計的互感器測量精度滿足電網中對于檢測的要求。最后為解決磁芯受溫度影響的問題,本文針對磁芯的溫度場建立了ANSYS模型,在同等條件下觀察溫度與磁芯磁導率的關系。在確定了溫度與磁芯磁導率的關系之后,針對當前時刻待測電流的不同,觀察不同的待測電流與磁芯磁導率的關系,針對這兩種對磁芯磁導率的影響源提出相對應的補償策略。
[Abstract]:DC power supply system in power system is a complex and high depth system. It is very important to measure DC leakage current to ensure the normal operation of power system. Magnetic modulation transformer is widely used to measure DC leakage current in power system. However, the traditional magnetic modulation transformer algorithm is not very suitable for measuring DC leakage current. There is little research on the effect of temperature on transformer. In this paper, the traditional magnetic modulation transformer algorithm is improved to make it suitable for measuring DC leakage current. And designed a transformer system using the improved algorithm. The ANSYS temperature field modeling for the core, a better understanding of the impact of temperature on the transformer, and proposed a compensation method for this impact. It can make up for the deficiency of the existing research and improve the current level of DC leakage current measurement. This paper analyzes the research results related to this topic at home and abroad, and summarizes the existing methods of measuring DC leakage current. The measurement of DC leakage current and existing related research results are deeply studied, and a reasonable measurement method is put forward. A DC small current transformer based on FPGA is designed. The transformer is divided into two aspects: hardware design and software design. Hardware design provides a platform for software design. Because the FPGA has a lot of IO resources, it is possible to expand the multiplex transformer in the future. The software part uses the kernel of FPGA, and has two output modes: serial port output and DA voltage output. Through the experimental data, it is proved that the measuring accuracy of the transformer designed in this paper meets the requirements of the detection in the power network. Finally, in order to solve the problem that the core is affected by the temperature, the output of the transformer is more intuitionistic. In this paper, the ANSYS model is established for the temperature field of magnetic core, and the relationship between temperature and permeability is observed under the same conditions. After determining the relationship between temperature and permeability of magnetic core, the difference of current to be measured at present is discussed. The relationship between different measured current and magnetic core permeability is observed, and the corresponding compensation strategies are put forward for the two kinds of influence sources of magnetic core permeability.
【學位授予單位】：華北電力大學
【學位級別】：碩士
【學位授予年份】：2017
【分類號】：TM45

【參考文獻】

相關期刊論文 前10條

1 曾詠奎;王維民;張婭;姚劍飛;;轉子-軸承系統中電磁作動器的Ansys仿真及實驗研究[J];北京化工大學學報(自然科學版);2014年03期

2 盧峰;;熱壁加氫反應器熱箱區有限元應力分析[J];一重技術;2013年05期

3 吳莉佳;胡博;于潤橋;郝延松;;瞬變電磁法檢測埋地金屬管道腐蝕模型的ANSYS仿真[J];失效分析與預防;2013年02期

4 王文昌;張濟麟;;直流分流器與直流分壓器結構原理及現場應用分析[J];計算技術與自動化;2012年02期

5 王堯;李奎;郭志濤;岳大為;牛峰;;磁調制式直流漏電流互感器[J];電工電能新技術;2012年02期

6 劉倩;吳丹;章婷;沈森祖;;FPGA可配置資源測試方法研究[J];宇航計測技術;2012年01期

7 夏琰;師衛;;硬件描述語言與數字電路設計[J];電力學報;2009年02期

8 陳鵬;;電流互感器誤差因素分析[J];云南電力技術;2008年06期

9 楊風開;;磁調制式直流小電流有源傳感器[J];儀表技術與傳感器;2008年10期

10 高艷豐;蘇秀蘋;閆紅艷;路海龍;;電磁式電壓互感器的電磁場分析及優化設計[J];江蘇電器;2007年01期

相關碩士學位論文 前2條

1 文藝;電連接器溫度場數值分析研究[D];河北工業大學;2012年

2 劉小波;干式變壓器漏磁場及溫度場的分析與研究[D];河北工業大學;2011年

，

本文編號：1607947