一種單級高頻AC-AC變換器的低通輸入濾波器的參數設計
發布時間:2018-03-06 17:33
本文選題:單級高頻AC-AC變換器 切入點:輸入濾波器 出處:《電工技術學報》2017年13期 論文類型:期刊論文
【摘要】:單級高頻AC-AC變換器將工頻電網電壓轉換為高頻(一般大于100k Hz)正弦交流電壓,并實現功率因數校正的功能。由于其功率因數校正單元工作于電流斷續模式(DCM),使得輸入電流含有大量高次諧波,需采用低通輸入濾波器予以濾除。上述低通輸入濾波器的濾波參數不僅影響其濾波性能,還會影響到輸入功率因數等諸多方面,因此濾波參數的確定十分重要。首先,根據疊加定理分別建立變換器交流側等效電路模型,即工頻分量和開關頻率分量單獨作用下的等效電路;進而,根據濾波器輸入、輸出要求合理設置相關預設參數,使加入濾波器后電網輸入側滿足能量之星關于功率因數的要求。在此基礎上以LC低通輸入濾波器為例,對輸入濾波器參數的定量設計過程進行詳細闡述,并歸納出一種程序化的設計方法;最后,進行仿真及實驗驗證設計方法的正確性,該方法也可用于單級有源功率校正器的輸入濾波器設計,而且對設計其他類型的低通輸入濾波器有借鑒價值。
[Abstract]:A single-stage high-frequency AC-AC converter converts the power frequency grid voltage to a high-frequency (generally more than 100kHz) sinusoidal AC voltage. The function of power factor correction is realized. Because the power factor correction unit works in the discontinuous mode of current, the input current contains a large number of high-order harmonics. The filtering parameters of the lowpass input filter not only affect its filtering performance, but also affect the input power factor and so on. Therefore, it is very important to determine the filter parameters. According to the superposition theorem, the equivalent circuit model of AC side of the converter is established, that is, the equivalent circuit acting separately by the power frequency component and the switching frequency component, and then, according to the input and output requirements of the filter, the relevant preset parameters are reasonably set up. The input side of the power grid can meet the power factor requirements of the energy star after adding the filter. Based on this, taking LC low-pass input filter as an example, the quantitative design process of the input filter parameters is described in detail. Finally, simulation and experiment are carried out to verify the correctness of the design method, which can also be used in the input filter design of single-stage active power corrector. Moreover, it is valuable to design other types of low-pass input filters.
【作者單位】: 輸配電裝備及系統安全與新技術國家重點實驗室(重慶大學);
【分類號】:TM46;TM761
【相似文獻】
相關碩士學位論文 前1條
1 唐棟材;組合式多電平AC-AC變換器研究[D];南京理工大學;2009年
,本文編號:1575803
本文鏈接:http://sikaile.net/kejilunwen/dianlidianqilunwen/1575803.html
最近更新
教材專著