【摘要】：利用浸漬法制備連續碳纖維增強聚醚醚酮(CF/PEEK)預浸帶,對其成型溫度、行進線速度進行研究,并測試了CF/PEEK預浸帶的熱脹系數、拉伸性能,利用SEM掃描電鏡觀察CF/PEEK預浸帶內部界面結合狀態。結果顯示,預熱區、熔融熱壓區溫度分別控制在110~130℃和220~370℃,預浸帶行進線速度控制在2 m/min時,制備的預浸帶性能較好;在-150~+150℃范圍內,CF/PEEK預浸帶線脹系數為0.5×10-6/K,并隨著纖維體積分?jǐn)?shù)增大而減小;CF/PEEK預浸帶最大拉伸強度達到1.81 GPa;SEM掃描電鏡顯示碳纖維與PEEK界面結合良好。研究顯示,CF/PEEK預浸帶制備工藝參數可行,CF/PEEK預浸帶性能較好,具有工程應用價值。
文內圖片：
圖片說明：預熱區及熔融熱壓區溫度分布示意圖
[Abstract]:The continuous carbon fiber reinforced polyether ether ketone (CF/PEEK) prepreg belt was prepared by impregnation method. The molding temperature and travel line velocity of the continuous carbon fiber reinforced polyether ether ketone (CF/PEEK) prepreg belt were studied. The thermal expansion coefficient and tensile properties of the prepreg belt were measured. The interfacial bonding state of the prepreg belt was observed by SEM scanning electron microscope. The results show that the properties of the prepreg zone are better when the temperature of the prepreg zone is controlled at 110 脳 130 鈩，

本文編號：2511437