【摘要】：采用均勻設計法,以鹽酸和氫氧化鈉為酸堿處理劑,制備pH值在1.90~13.70的玻璃纖維與鋁箔表面。以704硅橡膠作為粘結劑,將處理過的玻璃纖維與鋁箔在140℃熱壓60s制成玻璃纖維復合鋁箔材料。用動態熱機械性能測試儀(DMA)考察膠結界面pH值在30~400℃下,玻璃纖維復合鋁箔動態模量隨溫度的變化情況。結果表明:當玻璃纖維界面pH值呈中性,鋁箔界面pH值呈弱堿性時,復合材料的動態模量比其他膠結界面pH值都大;且隨著溫度的增加,其動態模量相應增加,并在200℃時達到最大值。掃描電鏡(SEM)實驗證明,在此條件下制備的復合材料膠結界面更為緊密,且玻璃纖維絲有部分嵌入鋁箔表面層結構。
[Abstract]:The surface of glass fiber and aluminum foil with pH value of 1.90 ~ 13.70 was prepared by uniform design method with hydrochloric acid and sodium hydroxide as acid-base treatment agent. Using 704 silicone rubber as binder, the treated glass fiber and aluminum foil were hot-pressed for 60 s at 140 鈩，

本文編號：2401074