【摘要】：針對含薄壁鋼內襯的碳纖維纏繞圓筒典型結構,建立三維有限元模型,采用溫度參數法逐層計算內襯剩余應力,并預測其承壓性能;基于水壓爆破試驗,研究了多纏繞角下纏繞張力、不同碳纖維等級對鋼內襯及復合材料圓筒承壓能力的影響,并結合鋼內襯的聲發射振鈴計數特征判別載荷屈服點。試驗結果表明,含薄壁鋼內襯的碳纖維纏繞圓筒的最佳纏繞張力為75 N左右,T700,T300兩種強度碳纖維復合圓管的鋼內襯最大屈服載荷基本相同。
[Abstract]:A three-dimensional finite element model is established for the typical carbon fiber wound cylinder with thin-walled steel lining. The residual stress of the liner is calculated layer by using the temperature parameter method, and its bearing capacity is predicted. Based on the water pressure blasting test, the influence of winding tension and carbon fiber grade on the bearing capacity of steel lining and composite cylinder under multi-winding angle was studied, and the load yield point was determined by combining the characteristics of acoustic emission ring counting of steel lining. The test results show that the optimum winding tension of carbon fiber winding cylinder with thin-walled steel lining is about 75 N, and the maximum yield load of steel lining of T700 and T300 carbon fiber composite pipe is basically the same.
【作者單位】： 軍械工程學院火炮工程系;河北太行機械工業有限公司;
【基金】：軍隊重點攻關項目(ZS2015070132A12002)
【分類號】：TB302

【相似文獻】

相關期刊論文 前2條

1 徐光磊;阮文俊;王浩;楊慶平;;含內襯纖維纏繞筒水壓試驗分析[J];兵器材料科學與工程;2012年04期

2 馬若涓;鄭長卿;吳國運;鄭秀芳;張桂芳;;CF鋼臨界空穴擴張比參數的測試研究[J];實驗力學;1989年02期

，

本文編號：2301848