本文選題：非織造布 + 管道修復　； 參考：《現代紡織技術》2017年02期

【摘要】：基于管狀紡織復合材料在翻襯過程中要求承受復雜的應力與應變,對非織造布復合材料的研制工藝和性能進行了探討。以壓強、溫度和時間3因子正交試驗研究了熱壓復合工藝,探索了樹脂配比和固化時間對真空輔助成型(VARI)工藝的影響,最后采用熱壓復合和VARI聯合工藝制備了非織造布復合材料并對其進行了表征。結果表明:熱壓成型工藝的最佳工藝為壓強5 MPa、溫度為140℃、時間為90s;樹脂、固化劑和稀釋劑的質量比為100∶80∶20;非織造布復合材料的斷裂應力達到了21 MPa以上,即表明非織造布復合材料研制工藝設計的合理性。
[Abstract]:Based on the complex stress and strain of tubular textile composites in the process of lining turning, the development process and properties of nonwovens composites are discussed in this paper. Based on the orthogonal test of pressure, temperature and time, the hot pressing process was studied, and the effects of resin ratio and curing time on the vacuum assisted molding (VARI) process were explored. Finally, nonwoven composites were prepared and characterized by hot pressing and VARI. The results show that the optimum process of hot pressing is pressure 5 MPA, temperature 140 鈩，

本文編號：1914610