本文選題：馬來酸酐 + 硅烷偶聯劑��； 參考：《長春工業大學》2015年碩士論文

【摘要】：本文以聚已內酰胺(尼龍6)為原料利用硅烷偶聯劑處理過的玻璃纖維進行增強改性研究制備了玻璃纖維增強尼龍6復合材料(GF/PA6)。1、采用同一處理?xiàng)l件分別應用KH550、KH560、KH570、KH792、DL602五種不同種類的偶聯劑對玻璃纖維進行處理考察了偶聯劑種類對復合材料力學性能的影響。結果表明硅烷偶聯劑可以附著在玻璃纖維表面偶聯劑處理液種類對處理效果有影響。不同型號的硅烷偶聯劑處理后的玻璃纖維制備的復合材料的性能不同在考察的五種偶聯劑中經過KH550處理的復合材料彈性模量和斷裂強度最大。硅烷處理液種類對復合材料的沖擊強度影響不大。2、采用同一種硅烷偶聯劑KH550考察硅烷偶聯劑處理液的濃度對復合材料力學性能的影響結果表明,硅烷偶聯劑可以附著在玻璃纖維表面硅烷偶聯劑處理液濃度對處理效果有影響。PA6/GF復合材料的彈性模量和斷裂強度隨玻璃纖維處理液濃度升高先增加后降低硅烷處理液濃度為1.5%時出現最大值。硅烷處理液濃度對復合材料的沖擊強度影響不大。3、通過硅烷偶聯劑作為連接橋梁研究了馬來酸酐(MAH)接枝玻璃纖維(GF)使之生成MAH-KH570-GF與PA6共混制備了玻璃纖維增強尼龍6復合材料(PA6/GF)�？疾炝笋R來酸酐對復合材料力學性能的影響。結果表明MAH與GF發生化學反應復合材料彈性模量和斷裂強度均得到提高GF表面的處理對其沖擊強度影響不大。
[Abstract]:In this paper, the glass fiber reinforced nylon 6 composite material was prepared by using polycaprolactam (nylon 6) as raw material and silane coupling agent was used to strengthen and modify the glass fiber. The glass fiber reinforced nylon 6 composite material was prepared. Five kinds of glass fiber reinforced nylon 6 composites were prepared under the same treatment conditions. The effects of different kinds of coupling agents on the mechanical properties of the composites were investigated. The results show that silane coupling agent can be attached to the surface of glass fiber. The properties of fiberglass composites treated with different types of silane coupling agents were different. The elastic modulus and fracture strength of the composites treated with KH550 were the largest among the five coupling agents investigated. The type of silane treatment solution had little effect on the impact strength of the composite. The effect of the concentration of silane coupling agent on the mechanical properties of the composite was investigated by using the same silane coupling agent KH550. Silane coupling agent can be attached to the surface of glass fiber. The concentration of silane coupling agent treatment has an effect on the treatment effect. The elastic modulus and fracture strength of PA6 / GF composites increase first and then decrease with the increase of glass fiber concentration. The maximum value was found when the concentration of liquid was 1.5. The concentration of silane treatment solution had little effect on the impact strength of the composite. By using silane coupling agent as the bridge, the maleic anhydride (MAH) grafted glass fiber (GFF) was prepared to form MAH-KH570-GF and PA6 blend to prepare glass fiber reinforced nylon 6 composite (PA6 / GFN). The effect of maleic anhydride on the mechanical properties of composites was investigated. The results show that the surface treatment of GF has little effect on the impact strength of MAH / GF composites when their elastic modulus and fracture strength are improved.
【學位授予單位】：長春工業大學
【學位級別】：碩士
【學位授予年份】：2015
【分類號】：TB332

【參考文獻】

相關期刊論文 前10條

1 高志秋,陶煒,金文蘭,張福軍,張淑偉;長玻纖增強尼龍6復合材料研究[J];工程塑料應用;2001年07期

2 唐偉家;世界尼龍工程塑料需求增長強勁[J];工程塑料應用;2004年05期

3 張志堅;章建忠;盧偉利;;短切原絲增強尼龍復合材料的性能研究[J];工程塑料應用;2011年06期

4 靳志森;;硅烷偶聯劑對玻纖/聚丙烯復合材料的影響[J];玻璃;2011年06期

5 彭超;鄭玉嬰;;改性尼龍6復合材料的力學性能研究[J];福州大學學報(自然科學版);2006年04期

6 鄭玉嬰;王燦耀;傅明連;王良恩;;Kevlar纖維增強尼龍6復合材料的界面結晶效應[J];高分子材料科學與工程;2005年06期

7 史亞君;硅烷偶聯劑的界面性能研究及機理探討[J];國外建材科技;2005年04期

8 張志堅;花蕾;李煥興;崔麗榮;;硅烷偶聯劑在玻纖增強復合材料領域中的應用[J];玻璃纖維;2013年03期

9 易長海,周奇龍,許家瑞,曾漢民;硅烷偶聯劑處理玻璃纖維表面的形態及活化機理[J];荊州師范學院學報;2001年02期

10 趙永紅,張發饒;尼龍6增韌研究進展[J];塑料工業;2003年08期

，

本文編號：1870555