本文選題：聚四氟乙烯 + 復合材料　； 參考：《塑料工業》2017年02期

【摘要】：以滑石粉為填料制備滑石粉/聚四氟乙烯(PTFE)復合材料,研究了滑石粉用量對復合材料密度、硬度、摩擦磨損及熱力學性能影響。結果表明,當滑石粉質量分?jǐn)?shù)從0%增加到20%時,復合材料的硬度、密度逐漸增加;滑石粉能顯著增加復合材料耐磨性能。當滑石粉質量分?jǐn)?shù)為20%時,復合材料磨耗量?jī)H相當于純PTFE的1/2 000(磨損條件為200 N,2 h,200 r/min);復合材料的結晶度隨滑石粉填充量的增加先下降后升高,當滑石粉質量分?jǐn)?shù)為20%時,復合材料的結晶度為三者中最高,比純PTFE提高了17%。
[Abstract]:Talc / PTFE composites were prepared with talc powder as filler. The effects of talc content on density, hardness, friction and wear and thermodynamic properties of the composites were studied. The results showed that when the mass fraction of talc powder increased from 0% to 20%, the hardness and density of the composites increased gradually, and the wear resistance of the composites increased significantly. When the mass fraction of talc powder is 20, the wear capacity of the composite is only 1 / 2 000 of that of pure PTFE (the wear condition is 200NU 2 h ~ 2 h ~ 200 r / min). The crystallinity of the composite decreases firstly and then increases with the increase of talc content, and when the mass fraction of talc powder is 20%, the crystallinity of the composite decreases first and then increases with the increase of the talc content. The crystallinity of the composite is the highest of the three, which is 17% higher than that of pure PTFE.
【作者單位】： 浙江大學浙江加州國際納米技術研究院;
【基金】：浙江省教育廳項目(Y201328296) 國際合作項目(2011DFR50150)
【分類號】：TQ325.4;TB332

【相似文獻】

相關期刊論文 前2條

1 劉承業,劉韶東;新型無石棉摩阻材料研究[J];淮海工學院學報(自然科學版);2000年01期

2 ;[J];;年期

，

本文編號：1860209