本文選題：復合材料　切入點：聚醚醚酮復合材料　出處：《全科口腔醫學電子雜志》2016年15期 　論文類型：期刊論文

【摘要】：實驗采用模壓方法制備短碳纖維和聚醚醚酮復合體,是一種較為便捷的制備方法,所獲得材料氣孔少,密度與理想密度相接近。通過材料切開面觀察以及密度測量,探討分析模壓中參數對CF-PEEK復合體材料密實性的影響,優化出較佳的模壓溫控程序參數以及操作細節。實驗得出的工藝:模壓制備材料為100目CF-PEEK粉料,模塊與磨具之間加墊石墨紙,冷壓下充分預排氣,200℃時多次加壓熱排氣并壓制至位點(壓力小于5MPa),在五段式溫控程序調節下完成模壓,最終完全冷卻至室溫時脫模。
[Abstract]:In the experiment, short carbon fiber and polyether ether ketone complex were prepared by moulding method. It is a convenient method to prepare short carbon fiber and polyether ether ketone complex. The porosity of the materials obtained is less and the density is close to the ideal density. This paper discusses the influence of parameters in molding on the compactness of CF-PEEK complex, and optimizes the program parameters and operating details of molding temperature control. The process obtained from the experiment is as follows: the material prepared by moulding is 100 mesh CF-PEEK powder, The graphite paper padded between the module and the grinder is fully pre-drained under cold pressure at 200 鈩，

本文編號：1649088